Isolite MAX Installation Manual

IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should always be followed including the following:
ƒ READ AND FOLLOW ALL SAFETY INSTRUCTIONS
ƒ Disconnect power before performing work on electrical equipment.
ƒ Use caution when servicing batteries. Battery acid can cause burns to skin and eyes. If acid is spilled on skin or eyes,
flush with fresh water and contact a physician immediately.
ƒ Equipment should be mounted in locations and at heights where unauthorized personnel will not readily subject it
to tampering.
ƒ The use of accessory equipment not recommended by BeLuce Canada Inc. as it may cause an unsafe condition, and
will void the unit's warranty.
ƒ Do not use this equipment for other than its intended purpose.
ƒ Servicing of this equipment should be performed by qualified service personnel.
MAINTENANCE
The equipment is to be tested once a year in accordance with the code requirements. The equipment is to be repaired
whenever the equipment fails to operate as intended during the duration test. Written records of test results and any
repairs made must be maintained. Beluce Canada Inc. strongly recommends compliance with these code requirements.
The lamps listed herein when used according to the instructions with this unit are in accordance with the requirements
of CSA Standard C22.2, No. 141 – Unit Equipment for Emergency Lighting.
NOTE: The servicing of any parts should be performed by qualified service personnel only. The use of replacement parts
not furnished by the manufacturer may cause equipment failure and will void the warranty.
ISOLITE  WWW.ISOLITE.COM
ISOLITE HEADQUARTERS  800.888.5483  31 WATERLOO AVENUE, BERWYN, PA 19312
ISOLITE WEST  800.799.5343  3563 SUELDO SUITE M, SAN LUIS OBISPO, CA 93401
MAX / MAX2.0 / MAX-E / MAX-C
SAVE THESE INSTRUCTIONS
Installation Manual
Wet Location Die-Cast Exit Sign