FAIRHAVEN HEALTH ibasal Instructions Manual

ibasal Thermometer Instructions
Computerized Basal Body Thermometer (BBT)
Please read the instructions carefully before you begin use.
Button Key:
Display Window
Temperature
Start measurement
probe
Set button/D T
Left Arrow/Memo button
Heart/Right Arrow button
1. Starting your first cycle
IMPORTANT: You can begin using the ibasal as soon as you receive it to familiarize yourself
with the process. The ibasal considers your first cycle to be a practice cycle and does not
calculate fertility predictions or your average temperature. Please note, however, that you can
still input your basal temperatures at OvaGraph.com during this first cycle and interpret them
manually. To begin taking your temperature, remove the protective film. Set date, time and
alarm so you can begin use the next day.
2. Getting ready to use the ibasal
1. Setting the time and date
Select with the Set button. The selected symbol will blink.
"Year" will blink
"Month" will blink
Set the year, month, day, hour and minute. The year
will blink. Use the left and right arrow buttons to adjust
the year. Once it is correct, press the Set button to save.
It will then move to the next value that you will need to
"Day" will blink
modify. Continue the same pattern to set the month,
day, hour and minute correctly.
"Hour" will blink
* Please note: if you do not press any buttons for
one minute, the screen will return to the original
display. If this occurs, please follow the steps to
"Minute" will blink
proceed to the setting you were adjusting.
Delete button
Graph/Check button
Mode button
Reset
button
Left arrow
Right arrow
ibasal Symbols
Setting the clock
Setting the alarm
Deleting the memo
1st day of menstruation
Delete the 1st day of
menstruation
Correct the 1st day of
menstruation
Delete the measurement
When you remove the protective film, the ibasal will automatically mark today as
cycle day 1. Please note: it is okay if the cycle day on the ibasal does not correctly
match with your actual cycle day. When you start your next cycle, follow the
instructions in the section called "Starting your second cycle."
You must set the clock and alarm before you begin use.
2. Setting the alarm clock
You cannot measure your temperature without setting the alarm.
If you do not take your reading when the alarm sounds, the alarm
will continue for 10 minutes and then shut off for the day.
The selected symbol will blink
Select
"Alarm hour" will blink
"Alarm minute" will blink
"Alarm OFF" will blink
- Page 1 -
Inserting the battery
Turn the device over and pull off the battery cover.
Pull and remove the cellophane protection film to turn
on the device. You will hear a beep and the display will
appear in the display window. Once the ibasal is
powered on, it will stay on.
Slide the battery cover
back side
Remove the
cellophane film
If the display does not appear, press the Reset button
or take out the battery once and insert it again.
Take out the battery here
Press the Mode button. Symbols appear in the display.
with the Right arrow button. Confirm with the Set button.
Set the alarm hour and minute. First set the alarm
hour using the left and right arrows, and press Set
to save. Follow the same process when settng the
minute.
Only set the alarm once you are ready for use.
Otherwise, keep the alarm set to OFF by
scrolling through the hours until you see OFF
appear on the screen. Press Set. In order to
store data, you must take your reading each
morning when the alarm sounds.
Bar graph blinks
alternately