Advertisement
Available languages
Available languages
have to do is press the "STANDBY" button
to turn off the fan.
4. To increase the wind area inside the
room, press the "OSCILLATION" button,
then the fan will oscillate and the wind will
blow in a wider area of the room. To exit
this mode, all you have to do is press the
same button again. Moving the fan head
up or down will change the direction of the
wind.
5. To turn off the fan completely, set all
the buttons to "STANDBY" mode and un-
plug the plug.
Instructions for using the remote
control
1. Place two 1.5V batteries on the back
of the remote control.
2. The remote control, controls all
the functions of the base part for
easy performance. Follow the basic
instructions for remote control of the
fan.
Note: Do not use the old battery with
the new battery.
3. Please remove the batteries when
you are not use the fan for a long time.
Setup the fan
ON/SPEED switch
The wind speed will be change from 1 to
6, for this you can press SPEED button
repeatedly, the speed will be change. in
speed of 6 if you press SPEED button
one more time, it will turn back to speed
1 again.
2. OFF switch
Press the OFF switch to turn the de-
vice off.
3. Oscillating
Press the OSC button and the head
starts to rotate, then press it again, the
fan will stop rotating.
4. TIMER switch
The fan can work at 30mins, 60mins,
120mins and 240mins by setting the
timer.
Remarks: The function of Item 2,3,4,5
are also can be realized by remote
control.
Manual setting of wind direction
The angle of the fan head is adjustable,
it can facing upwards and downwards
by slightly lift or press the cover.
Troubleshooting
When starting the fan, the fan blade
doesn›t work, please check whether
the power plug has really inserted into
the socket or the cover has distorted,
which has touched the fan blade. If
sound the noise when starting the fan,
please check the unit as following:
1
.
Fan blade has been tight installed into
the output shaft of motor.
2.Groove on back of cover has matched
the inserting groove on the output shaft.
3. There are tiny defective edge ring
existing around the fan blade.
4. The cover has distorted, which has
touched the fan blade.
Cleaning and maintenance
For safe care of the device, please
keep in mind the following safety tips:
1. Always unplug the appliance before
cleaning it and wait for it to stop com-
pletely.
2. Before removing the guard, make
sure that the power supply to the fan
is cut off.
NS-1116
Stand Fan
6
Advertisement
