WavestoreUSA Vision 5MP Installation Manual

WavestoreUSA Vision 5MP Installation Manual

Compact ir dome ip camera

Advertisement

Quick Links

Wavestore Vision 5MP
Compact IR Dome IP
Camera Installation Guide
WV-5D-28F
Before installing and using the camera,
please read this manual carefully.
Be sure to keep it handy for future reference.

Advertisement

Table of Contents
loading

Summary of Contents for WavestoreUSA Vision 5MP

  • Page 1 Wavestore Vision 5MP Compact IR Dome IP Camera Installation Guide WV-5D-28F Before installing and using the camera, please read this manual carefully. Be sure to keep it handy for future reference.
  • Page 2: Table Of Contents

    Contents INTRODUCTION Important Safety Information Product & Accessories Part Name INSTALLATION Disassemble the Camera Installation Installation using Mount Bolt & Nut Adjusting the camera angle Cabling Inserting / Removing an SD Memory Card SPECIFICATION Dimension...
  • Page 3 Safety Instruction These instructions are intended to ensure that the user can use the product correctly to avoid danger or property loss. If the product is not functioning properly or damaged, contact the service center or purchasing office. Warnings Cautions Serious injury or death may be caused Injury or equipment damage may be caused if any if any of these warnings are neglected.
  • Page 4 Installation and Use Precautions The battery (battery pack or equipped battery) must not be exposed to excessive heat such as sunlight, fire, etc. Do not disassemble the camera at your discretion. If you forcefully install the product with excessive force, malfunction can damage the camera. Do not punch or shake the camera and be careful not to damage the camera with careless storage or malfunction.
  • Page 5 Disposal of Old Appliances 1. When this crossed-out wheel bin symbol is attached to a product it means the product is covered by the European Directive 2002/96/EC. 2. All electrical and electronic products should be disposed of separately form the municipal waste stream stream in accordance to laws designated by the government or the local authorities.
  • Page 6: Introduction

    Introduction - Product & Accessories Camera Cables Template Sheet Screw & Quick Manual for Installing by Bolt & Nut Plastic Anchor - 2pcs Waterproof cap & Gasket Mount Bolt & Nut Torx Wrench & Rubber 2ea (Black : ø4 / White : ø5) Note : Cable thickness 4.5ø...
  • Page 7: Part Name

    Introduction - Part Name Dome Cover Panning Stopper Lens IR Switch Gimbal IR LED SD Card Slot Reset Button Bottom Case DC Power Jack RJ-45 Connector Waterproof cap...
  • Page 8: Installation

    Installation - Disassemble the camera Before installing your camera, you have to read the following cautions. 1. You have to check whether the location can bear five times of the weight of your camera. 2. Don’t let the cable to be caught in improper place or the electric line cover to be damaged. Otherwise it may cause a breakdown or fire.
  • Page 9: Installation

    Installation - Installation Template Sheet Disassemble the camera. See the section ‘Installation - Disassemble the camera’ for details. Using the template sheet, make the cabling hole on the wall/ceiling. Connect the network cable and power cable respectively. See the section 'Installation - Cabling' for details. Insert the Lan cable into the rubber first as (a) below.
  • Page 10: Installation Using Mount Bolt & Nut

    Installation - Installation Using Mount Bolt & Nut Template Sheet Disassemble the camera. See the section ‘Installation - Disassemble the camera’ for details. Using the template sheet, make the cabling holes on the ceiling panel. Insert the 2 mount bolts into bottom case of camera.
  • Page 11 Installation - Installation Using Mount Bolt & Nut Insert the mount bolts into template holes after connecting the cable. Fix the bottom case by tightening mount nuts to mount bolts on the ceiling panel. To achieve desired view direction and orientation, rotate 3-axis gimbal.
  • Page 12: Adjusting The Camera Angle

    Installation - Adjusting the Camera angle Panning 355° Rotation 360° Tilting 60°...
  • Page 13: Cabling

    Installation - Cabling Two Options Use a PoE-enabled swtich to connect data and power through a single cable and begin viewing and recording images instantly. A non-PoE switch will require an adaptor for power transmission. 1. Using a PoE-Enabled Switch 2.
  • Page 14: Inserting/Removing An Sd Memory Card

    Installation - Inserting/Removing an SD Memory Card The memory card is an external data storage device that has been developed to offer an entirely new way to record and share video, audio, and text data using digital devices. Micro Recommended SD Card Specification (Not Included) - Type: Micro SD (SD/SDHC/SDXC) - Manufacturer: SanDisk, Samsung, Transcend, Micron...
  • Page 15: Specification

    Specifications - Dimension Unit : mm 28.2 32.5 ø105...

This manual is also suitable for:

Wv-5d-28f

Table of Contents