Flipper ZERO FZ.1 Quick Start

Flipper Zero
Powered OFF
To update the firmware connect your device to your computer
via USB cable and go to: https://update.flipperzero.one
It's important to install the latest firmware available in order
to take advantage of all the enhancements and bug fixes.
UPDATING...
Twitter: @flipper_zero
Updating Firmware
• Read the Documentation: docs.flipperzero.one
• Talk to us on Discord: flipp.dev/discord
• Discuss features on our Forum: forum.flipperzero.one
• Check out the source code: github.com/flipperdevices
• Report bugs: flipp.dev/bug
Facebook: @flipperzero
Quick Start
Read the full manual here:
https://docs.flipperzero.one
micro
Make sure to insert the microSD card as depicted.
Flipper Zero supports cards up to 256GB, but 16GB
should be enough.
You can format the microSD card automatically from
Flipper's menu or manually using your computer.
In the latter case, choose exFAT or FAT32 filesystem.
Flipper Zero works with microSD cards in SPI "slow mode".
Only authentic microSD cards properly support this mode.
See recommended microSD cards here:
https://flipp.dev/sd-card
Powering ON
Hold Back
If Flipper Zero is not starting, try
charging the battery with a USB cable
plugged into a 5V/1A power supply.
HOLD for 3 seconds
Rebooting
HOLD
Hold Left
You may encounter freezes, especially
while the firmware is in beta or when
using a dev version. If Flipper Zero stops
responding, please reboot your device.
For GPIO port manual, please visit
docs.flipperzero.one
SD card
for 3 seconds to turn ON.
update.flipperzero.one
+ Back
Links
Instagram: @flipper_zero
to reboot.