1. Manuals
  2. Brands
  3. 3D Fun Printz Manuals
  4. Printer Accessories
  5. Cord Holder
  6. Manual

3D Fun Printz Cord Holder Manual

Hide thumbs
1
2
3

Advertisement

Table of Contents

www.3dfunprintz.co.uk
Cord Holder
Thank you for purchasing the Cord Holder
There are some tips below to get the best out of
it.
Most importantly. The cord holder is made from
PLA as it is a natural plastic originating from corn
starch and is recyclable. For these reasons it
does not like heat.
Please don't leave it in the sun, on a hot
windowsill, on or near a radiator or anywhere else
with a lot of heat. Please also keep away from
children and pets. PLA can be sharp when broken.

To attach to the machine

The holder needs to be mounted centrally on top of
the machine as in the photograph below

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Cord Holder and is the answer not in the manual?

Questions and answers

Summary of Contents for 3D Fun Printz Cord Holder

  • Page 1 Thank you for purchasing the Cord Holder There are some tips below to get the best out of Most importantly. The cord holder is made from PLA as it is a natural plastic originating from corn starch and is recyclable. For these reasons it does not like heat.
  • Page 2 TIP – The plastic is cut in half to make it easier for you to remove You can then push the USB plug through the slot in the cord holder. You may need to wrap the cord label around the cord to push it through. Make sure there is enough cord to allow the machine full movement side to side.
  • Page 3 Once the holder is mounted you can unscrew the top part for transport if needed and leave the base attached to the machine. The base can be carefully removed at any point but the sticky pad will need to be replaced with another sticky pad.

Table of Contents