Page 1
Installation and Operation Manual Effective October 1, 2021 Designer Collection Shower System — Acrylic CXL DoloMatte Installer: This booklet must be given to the product owner. Please note important information below: Distributor Name _______________________________________ Model # ________________________________________ Manufacturer’s Date ____________________...
Page 2
Owner’s Manual & Installation Guide Thank you for purchasing an MTI bath product. You have chosen the best-built shower pan in the USA. The instructions in this booklet will provide you with the information needed to install and maintain this unit. The ease of cleaning and the elegant look will provide you with many years of pleasure.
Shower Systems Important Safety Instructions This manual contains information and instructions for proper handling, operation and maintenance of your MTI shower system. Failure to follow these instructions could result in personal injury, electrical shock or fire. WARNING: WHEN USING ELECTRICAL PRODUCTS, BASIC PRECAUTIONS SHOULD BE FOLLOWED INCLUDING THE FOLLOWING Do not permit children to use this unit unless they are closely supervised by an adult at all times.
Page 5
BEFORE INSTALLING • Inspect product(s) thoroughly. • Damage from shipping or delivery must be reported to carrier immediately. Do not install damage unit(s). MTI is not responsible for damage that occurs during transit. • Factory defect must be reported to factory before unit is installed. Defects or damage claimed after installation will be excluded from warranty.
Important: always allow bedding compound to dry for 24 hours before using shower system. ¹MTI does not warrant leaks associated with improper drain installation and will not be responsible for any costs related to improper installation. If you need assistance, please call the MTI Service Department at 800.783.8827.
Installation and Operational Manual • Designer Collection • Shower Systems Installation Instructions – Shower Pans Single Threshold with Integral Tile Flange INTEGRAL TILE FLANGE (MOLDED) FOR SINGLE AND DUAL THRESHOLD PANS The integral tile flange is molded into the shower pan at the factory. Backer Board •...
Radiance option. Must be connected to a supply that is protected by a ground fault circuit interrupter (GFCI). System components supplied with MTI tubs intended for installation within the U.S. & Canada are limited to 110V. Check your order details when installing outside of these territories.
Shower Systems Teak Shower Tray Teak shower trays by MTI are designed to fit each individual multi-threshold shower pan. Teak finish may be kept natural, stained or periodically treated with oil. Teak wood is inherently protected by its own natural oils and dense grain. Left in its natural state, the shower tray will assume a silver-gray patina over time.
To maintain its elegant look, follow these simple steps: • MTI recommends cleaning with a soft, damp cloth and any mild dish soap and water. Fingerprints may be removed with denatured alcohol applied to a soft cloth.
Page 11
Installation and Operational Manual • Designer Collection • Shower Systems NOTES mtibaths.com / 11...
The warranty registration card must be filled out by the purchaser within one hundred twenty days from purchase and submitted to MTI Baths in order for this warranty to take effect. Warranty registration may be mailed or completed online at mtibaths.com.
Page 13
MTI Baths, Inc. in addition to or different from those herein given, or to assume for MTI any other liability in connection with any of its product except in a written statement which is signed by an officer of MTI expressly and intentionally giving such warranties or expressing such liabilities.
The warranty registration card must be filled out by the purchaser within one hundred twenty days from purchase and submitted to MTI Baths in order for this warranty to take effect. Warranty registration may be mailed or completed online at mtibaths.com.
Page 15
MTI Baths, Inc. in addition to or different from those herein given, or to assume for MTI any other liability in connection with any of its product except in a written statement which is signed by an officer of MTI expressly and intentionally giving such warranties or expressing such liabilities.
Need help?
Do you have a question about the DoloMatte and is the answer not in the manual?
Questions and answers