CARQUEST Provalue 1500-CJ Operating Manual

Old 1500-CJ
New 1500-PV
750 LB. ENGINE STAND
DO NOT OVERLOAD. OVERLOADING CAN
CAUSE DAMAGE TO, OR FAILURE OF
THE STAND.
THIS STAND IS DESIGNED FOR USE ONLY
ON HARD LEVEL SURFACES CAPABLE OF
SUPPORTING THE LOAD. USE ON OTHER
THAN HARD LEVEL SURFACES CAN
RESULT IN STAND INSTABILITY AND
TIPPING OF LOAD.
LOCK THE MOUNTING-PLATE ROTATING
MECHANISM BEFORE APPLYING A LOAD.
RELEASE ROTATIONAL LOCKING DEVICE
SLOWLY AND CAREFULLY.
ALWAYS USE HIGH STRENGTH SAE GRADE
8 BOLTS FOR ENGINE MOUNTING BOLTS.
MAKE SURE WIDEST SET OF MOUNTING
HEAD FINGERS ARE NEAREST THE
GROUND WHEN MOUNTING AN ENGINE
TO THE STAND.
ALWAYS BE SURE THAT THE LOAD IS
CENTERED AND SECURED TO THE
MOUNTING PLATE. OFF-CENTER LOADS
MAY MAKE THE LOAD AND HANDLE
ROTATE IN EITHER DIRECTION WHEN
THE ROTATIONAL LOCKING DEVICE IS
Refer to Engine Service Manual for
RELEASED.
NEVER LOOSEN MOUNTING BOLTS Correct Lifting Points, Mounting
UNLESS ENGINE IS SUPPORTED BY A
Points and Mounting Bolts!
CRANE OR HOIST.
DO NOT USE STAND TO DOLLY OR
Mounting bolts should
TRANSPORT ENGINES.
be torqued at appropriate amount
NO ALTERATIONS TO THE STAND OR
ADAPTERS SHALL BE MADE.
to maintain load.
DO NOT ROTATE MOTOR UNLESS REAR
LEGS ARE SECURED FROM TIPPING.
READ, STUDY AND UNDERSTAND ALL
INSTRUCTIONS BEFORE OPERATING.
FAILURE TO HEED THESE WARNINGS MAY
RESULT IN LOSS OF LOAD, DAMAGE TO
STANDS, AND/OR FAILURE RESULTING IN
PROPERTY DAMAGE, PERSONAL OR
FATAL INJURY.
Parts Breakdown & OPERATING MANUAL
Rev. 04/17/03