Summary of Contents for Serenity SSE-1
- Page 1 Installation Manual ©2018 New Dawn Holdings,LLC and its affiliates Contact us at 888-392-9625 or email us at sales@serenityenclosures.com with any questions during the installation.
- Page 2 Floor Model Options Single Models Size: 46”d x 46”w x 88”h, 36”d x 36”w x 88”h - 89 1/2”h with roof Model SSE-1 Model SSE-2 Double Models Size: 46”d x 88”w x 88”h, 36”d x 68”w x 88”h – 89 ½”h with roof...
- Page 3 For soft ground surfaces, the unit must be secured to a base placed in the ground. The base will be filled with pea gravel to create a French drain under the flooring. 2x6 Base: You will need the following materials to create the base: Double 46"...
- Page 4 1.) Setting Frame (s): a. Remove the base frame from the box and lay on a flat surface PIC 1a where the shower unit will be installed. PIC 1a PIC 4a b. For double units make sure the center supports of both frames are in line with each other then fasten using Qty.
- Page 5 PIC 1b 3.) Installing Wall Panels and Post Bracket: (Make sure speed on drill is adjusted to a low speed) *If you purchased a Shower Valve Trim Set with removable wall panel put this aside and it will be the last panel you install.
- Page 6 4.) Outdoor Shower Trim Set Panel Installation: a. Install a header from post to post following the same instructions in 3a & 3b (PIC 3H) where the removable panel will go. Install another post bracket directly under the two supporting the header as you see in PIC 4a b.
- Page 7 7.) Installing Shower Door: *Note: For DSE-7, 8 and CSE 9 & 10 Models – Door swing must be in the same direction for Handle to Align Properly. Make sure the unit is secured to the surface and level so the door sits plumb. Determine your door swing prior to moving on.
- Page 8 8. Installing the Lock: Go to YouTube for a video of installing the lock…”SerenityEnclosureLockInstallation” • Be sure the drill is on a low speed. Remove the lock from the door hardware box and ensure deadbolt is in the closed position. *Important* a.
- Page 9 *IMPORTANT: YOU ARE READY TO ADJUST POSTS FOR EQUAL REVEAL AND TIGHTEN THE POST BOLTS SECURELY TO THE FRAME PIC 9a (1) 9.) Installing the Roof: *2 people are recommended for this step. If unit is being Installed against a structure, install post caps prior to Installing roof.
- Page 10 10.) Installing the Towel Bar/Hook Bar: *Note: You can install the towel and hook bar wherever desired on the inside or outside of the unit.…Standard install is as follows: PIC 10a a. Towel Bar: Measure 54” off finished floor and mark 2 adjacent posts (the desired Posts on the side where the towel bar will be placed).
-
Page 11: Caring For Your
Note: Some spray-on bug spray and sunscreen products may cause discoloration of the vinyl product surface. It is recommended to apply these products away from your Serenity Enclosure. Do not use any harsh cleaning products on aluminum components. You do not want to remove the... - Page 12 NDH Manufacturing, LLC. warrants to the purchaser of its Aluminum/Outdoor Shower enclosure product that it is free of defects in workmanship and materials and in the course of normal and proper use, it’s Shower Aluminum/Vinyl parts will not crack, peel, blister, flake, nor be subject to abnormal weathering per AAMA 2604 Specifications and as per ASTM F964 Specifications.
Need help?
Do you have a question about the SSE-1 and is the answer not in the manual?
Questions and answers