Kruger Titan Bold User Manual

Titan® Bold Electronic Hybrid Roll Towel Dispenser
Warning
To prevent fire or electric shock, do not expose the dispenser to rain or moisture. Keep the dispenser away from strong magnets,
heat sources, electrical wiring, and excessive dust. The dispenser is not to be used by persons (including children) with reduced
physical, sensory, or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or
instruction. Children shall not play with the appliance. This appliance is not a toy.
To reduce the risk of burns, fire, electric shock, or injury to persons:
1. Use this dispenser only for its intended use as described in these instructions.
2. Remove batteries before putting on, taking off parts or servicing the dispenser.
3. Close supervision is necessary when this dispenser is used by, or near children, invalids, or disabled persons.
Always remove batteries from the dispenser before cleaning or if dispenser is stored or unused for a long period of time.
4.
5. Do not use attachments not recommended by the manufacturer.
5. Never drop or insert any object into any opening.
6. Do not use outdoors.
8. Do not operate where aerosol (spray) products are being used or where oxygen is being administered.
9. The battery supply terminals are not to be short-circuited.
10. Different types of batteries or new and used batteries are not to be mixed.
11. Batteries are to be inserted with the correct polarity.
12. Exhausted batteries are to be removed from the appliance and safely disposed of according to local laws.
13. Non-rechargeable batteries are not to be recharged.
Cleaning
When cleaning, make sure to remove the batteries. Do not use liquid or aerosol cleaners. Use a cloth, lightly dampened with water
for cleaning the exterior of the dispenser. Compressed air or a vacuum can be used to clean out the interior should paper dust
accumulate. The recommended placement for the dispenser is 54" (137cm) from the floor to the bottom of the dispenser, as
recommended for ADA compliance.
Mounting the dispenser
Make sure that the dispenser is securely fixed to the wall using appropriate wall plugs or secured directly to a stud before using. Refer
to local building requirements where necessary. The recommended placement for the dispenser is 54" (137cm) from the floor to the
bottom of the dispenser. Mounting the dispenser to a metal surface is not recommended.
Legal Notices
FCC Part 15
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to
correct the interference at his own expense.
FCC Warning
Changes or modifications not expressly approved by the party responsible for compliance with the FCC rules could void the user's
authority to operate this equipment.
Specifications
Voltage Rating:
6.5VDC 2.5A - 4 X 1.5V, D cell Alkaline LR20 Batteries. Do not use rechargeable batteries.
Appliance can only be externally powered by the provided external power supply ICP30-065-3500 (purchased separately)
Recommended Operating Temperature
41°to 95° F (5° to 35°C)
Read all instructions before using this
SAVE THESE INSTRUCTIONS
dispenser.