Option 1. Top Mounting
Steps: (Hole cut out made to the specified sizing)
7. Remove filter to gain access to pre punched screw locating holes in the top
of the Rangehood
8. Connect wires to the 12powers source: red wires to positive pole(+),black
wire to negative pole(-)
9. Lift range hood into designated position
10. Mount using 4 only SS screws into pre punched locating holes (Shown
above)
11. Install filter
12. Test Rangehood and ensure unit is working correctly
Option 2. Side Mounting
Steps: (Hole cut out made to the specified sizing)
6. Remove filter to gain access to pre punched screw locating holes in the top
of the Rangehood
7. Connect wires to the 12volt powers source: red wires to positive
pole(+),black wire to negative pole(-)
8. Lift range hood into designated position
9. Mount using 4 only SS screws into pre punched locating holes (Shown
Above)
10. Install filter
11. Test Rangehood and ensure unit is working correctly
6