CONTENTS 1. GETTING STARTED Main features Package contents Battery charging Battery 2. INSTALLATION Installation of Speaker and Microphone Installation of cradle, bracket and BiT-4 main device 3. BUTTONS AND PORT 4. BASIC FUNCTIONS Power on / off Volume up / down Automatic power off Voice command 5.
Page 3
Universal Intercom mode 4 Riders Multi-Intercom mode Surround Monitoring mode Battery power level 7. PHONE FUNCTION Answering incoming call Rejecting incoming call Hanging up the call Automatic answering Holding the current call, answering an incoming call While in calling, rejecting another incoming call Last number redialing &...
Page 4
10. INTERCOM MODE Volume control in Intercom mode 1:1 Intercom pairing 1:1 Intercom connection / disconnection Audio Multi-Tasking 4 Riders Multi-Intercom pairing 4 Riders Multi-Intercom connection / disconnection 4 Riders Multi-Intercom reconnection and reposition 1:1 Intercom automatic re-connection 11. UNIVERSAL INTERCOM PAIRING Universal Intercom pairing with BiT-4 set as a master Universal Intercom pairing with Non-ChatterBox product set as a master Universal Intercom connection / disconnection...
14. RESET Reset Factory Reset 15. SMART-PHONE APPLICATION CONTROL 16. SOFTWARE UPGRADE 17. SUPPORT Precaution Limited warranty Limitation of liability Reasons for limited liabilities Disclaimer of liability Customer service center 18. FAQ (Frequently Asked Questions) 19. CE/FCC DECLARATION 20. SIMPLE MANUAL GETTING STARTED Thank you for choosing our ChatterBox BiT-4,...
Battery charging Connect the supplied USB charging data cable with a PC or wall charger. Be sure to charge the product using the USB charging data cable provided. Charge with a normal charger of 5V or less than 1.2A. Using a high-speed charger for Smart-phones or a supplementary battery with high-speed charging (9V, higher than 1.2A) may inflate the battery, cause an explosion, or damage internal circuits.
cause reduced battery capacity, battery life, or temporary inactivity. Long exposure of the product to direct sunlight in a hot temperature may cause circuit failure or battery failure. Do not use any product damaged by impact, circuit or battery failure may occur. ...
※ CAUTION: Repositioning of the Velcro stickers of the speakers and microphones more than one time may result in poor adhesion. ( Velcro stickers are available on the website, http://www.chatterboxglobal.com/) Open-Face microphone Ultra Slim Full-face microphone Speakers Cradle and Bracket Installation of cradle, bracket and BiT-4 main device Prepare the provided cradle, bracket, screws and L-wrench.
BUTTONS AND PORT BASIC FUNCTIONS Power On/Off: Long press POWER BUTTON for seconds. Volume Up: Press the PLUS BUTTON with intervals of longer than 0.5 seconds. Volume Down: Press the MINUS BUTTON with intervals of longer than 0.5 seconds. ※ CAUTION: Fast double-pressing within 0.5 seconds will result in searching next / previous song in Music mode OR that will result in scanning up and down channels in FM radio mode.
recognition function of your Smart-phone is activated. SMART-PHONE CONNECTION Smart-phone Pairing ① Make sure your BiT-4 device is powered off. ② Press and hold POWER BUTTON for seconds until the LED turns and flashes in Red and Blue alternately. [Voice Prompt: “Bluetooth pairing”] ③...
Page 12
Short double-press the FUNCTION BUTTON. FM radio Mode: Short double-press FUNCTION BUTTON. 1:1 Intercom Mode: (Rider & Passenger Intercom) To connect Intercom: Short press POWER BUTTON. To disconnect Intercom: Short press POWER BUTTON again. ※ Intercom Pairing must be preceded Universal Intercom Mode : To connect Intercom: Short double-press POWER BUTTON.
Page 13
‘4’ = 80~100% ‘3’ = 60~80% ‘2’ = 40~60% ‘1’ = 20~40% ‘Low Battery’ = 0~20% PHONE FUNCTIONS Answering an incoming call: Press the FUNCTION BUTTON shorter than 1 second. Rejecting an incoming call: Press the FUNCTION BUTTON longer than 1 second.
If you want to take off your helmet in the middle of phone conversation and you want to talk on your Smart-phone directly, press and hold the PLUS and MINUS BUTTONs simultaneously for longer than 1 second, then the call switch over from BiT-4 to your Smart-phone. In order to switch over back to BiT-4, do the same operation.
Music Sharing disconnection: Simultaneously press Music Sharing disconnection: Simultaneously press PLUS and FUNCTION BUTTON FUNCTION BUTTON until you hear a Beep sound. Music Sharing reconnection: Simultaneously press Music Sharing reconnection: Simultaneously press PLUS and FUNCTION BUTTON FUNCTION BUTTON until you hear a Beep sound.
Page 16
1:1 Intercom Pairing ① Place two devices to pair close to each other. ② Long press INTERCOM BUTTONs of both devices for 3 seconds until the LED flashes in red and blue alternately. [Voice Prompt: “Pairing”] ③ Short press INTERCOM BUTTON of the device to be set as a Master. [Voice Prompt: “Intercom Pairing”] Then, Red LED flashes fast to enter pairing mode.
Page 17
⑤ The second and the third device will be paired in the same pairing procedure. Each device The second and the third device will be paired in the same pairing procedure. Each device The second and the third device will be paired in the same pairing procedure. Each device can have only one Master and one can have only one Master and one Slave.
Page 18
Audio Multi-Tasking Audio Multi-Tasking allows the the 4 Riders Multi-Intercom can maintain the Intercom Intercom communication without being interrupted by a phone call, Music ted by a phone call, Music or FM radio sound. Briefly, you can listen to Music, Briefly, you can listen to Music, FM radio, and can make a Phone call while , and can make a Phone call while keeping the Intercom communication...
Page 19
1:1 Intercom Automatic Re- -connection If 1:1 Intercom conversation is disconnected by a distance or poor signal, your device will search for the If 1:1 Intercom conversation is disconnected by a distance or poor signal, your device will search for the If 1:1 Intercom conversation is disconnected by a distance or poor signal, your device will search for the previously paired device to reconnect for 2 minutes.
Page 20
① Place two devices to pair close to each other. ② Long press INTERCOM BUTTON for 3 seconds until the Red and Blue LEDs flash alternately. [Voice Prompt: Pairing] ③ Double press INTERCOM BUTTON of BiT-4. [Voice Prompt: “Group Pairing”] Then, Blue LED flashes fast to enter Universal pairing mode.
Page 21
12. SURROUND MONITORING MODE In case that you want to hear external sound without taking off your helmet, long-press the CRADLE BUTTON at the bottom of the cradle for 2 seconds. To exit, long press the CRADLE BUTTON for 2 seconds.
Page 22
(3) VOX SET UP VOX is a function to answer an incoming phone call by using loud voice or shouting without using any button. (As a phone rings, taking no action would lead to an automatic answer in 20 seconds) ①...
Page 23
Rebooting Reboot the device when the function stops working or if you cannot turn off the power of the device. To reboot the device, insert USB charging data cable while pressing and holding the MINUS (-) BUTTON. However, the pairing information, language setting, and saved FM radio channels will not be deleted.
Page 24
Store or use the product at temperatures of -15°C ~ +50°C. Too high and too low temperatures may damage, shorten capacity and life of the battery, or may cause the product to be inoperative. Keep the product out of direct sunlight. Exposing the product to direct sunlight may damage the ...
Page 25
In case of returning via courier, the end-user must be able to return the defective product with its original package along with a copy of the original purchase receipt from the store where the purchase was made. The warranty service will be provided through the store where the first purchase was made. ...
Page 26
Liabilities disclaimer In addition to damages which may occur due to the use of the product, Chatterbox will not be liable for damages of the product which occur due to the following events. In the event the product is misused or used for purposes other than its intended purpose. ...
Page 27
400 meters. For more detailed FAQ information, please access our website. (http://www.chatterboxglobal.com/) 19. CE/FCC Declaration Vereinfachte CE-Konformitätserklärung. Hiermit erklärt UNIMO TECHNOLOGY dass der Funkanlagentyp BIT-4 der Richtlinie 2014/53/EU entspricht.
Page 28
Der vollständige Text der EU-Konformitätserklärung ist unter der folgenden Internetadresse support/library verfügbar: http://www.chatterboxglobal.com/us/board/list.php?bdId=morgueEU Bitte beachten Sie, dass dieses Produkt Radiofrequenzbänder benutzt, die innerhalb der EU nicht harmonisiert sind. Innerhalb der EU darf dieses Gerät in Österreich, Belgien, Dänemark, Finnland, Frankreich, Deutschland, Griechenland, Irland, Italien, Luxemburg, den Niederlanden, Portugal, Spanien, Schweden, im Vereinigten Königreich und innerhalb der EFTA in Island, Norwegen und der Schweiz benutzt werden.
Page 29
Pour plus d’informations, veuillez consulter notre site internet/support/library : http://www.chatterboxglobal.com/us/board/list.php?bdId=morgueEU Veuillez noter que ce produit utilise des bandes de radio fréquence non uniformisées au sein de l’Union Européenne. Au sein de l’Union Européenne, ce produit est destinéàêtre utiliséen Autriche, Belgique, Danemark, Finlande, France, Allemagne, Grèce, Irlande, Italie, Luxembourg, Pays-Bas, Portugal, Espagne, Suède et Royaume-Uni et au sein de l’AELE, en Islande, Norvège et Suisse.
Page 30
Address: 11627 Telegraph Rd. Suite #103 Santa Fe Springs, CA蘮USA Website: www.chatterboxusa.com Customer service center in EUROPE Address: Talstrasse 39 D-77887-SASBACHWALDEN, GERMANY 20. SIMPLE MANUAL MODE FUNCTION OPERATION Power on Long press the POWER BUTTON for 3 seconds Power off Long press the POWER BUTTON for 3 seconds Volume control Short press the PLUS or MINUS BUTTON...
Page 31
Voice Command After stopping Music or FM radio, press the PLUS (Smart-phone’s Siri BUTTON longer than 1 second function) While being on the phone, While being on the phone, simultaneously press the switching device between PLUS and MINUS BUTTONs for 1.5 seconds BiT-4 and Smart-phone After pressing the POWER BUTTON for seconds,...
Page 32
Universal Intercom Short double-press the POWER BUTTON / connection /disconnection Short double-press the POWER BUTTON Multi-Intercom connection Short press INTERCOM BUTTON or / disconnection Short double-press INTERCOM BUTTON Intercom volume control Long press PLUS or MINUS BUTTON Verify the given number of Short press CRADLE BUTTON your device...
Need help?
Do you have a question about the ChatterBox BiT-4 and is the answer not in the manual?
Questions and answers