Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for DAN DRYER SOAPTAP 378
Summary of Contents for DAN DRYER SOAPTAP 378
- Page 1 USER MANUAL SOAPTAP Model 378 FOAMTAP Model: 382...
-
Page 2: Table Of Contents
TABLE OF CONTENTS DIMENSIONS AND TECHNICAL SPECIFICATIONS Dimensions and technical specifications Dimensions Unit of measurement: mm General safety information Installation Installation height User guide Ø38 Light indicator Cleaning and maintenance Refill of soap container Calibration of sensor range Troubleshooting and corrective actions Ø50 Symptoms and corrective actions: New soap dispenser Symptoms and corrective actions: Used soap dispenser... -
Page 3: General Safety Information
30° Ceramic ≥250 mm • Never make alterations to the product affecting its performance. DAN DRYER’s product Brushed steel ≥300 mm 30° warranty does not cover product problems that result from misuse or alteration. NOTE A minimum distance ≥180 mm... -
Page 4: Installation
INSTALLATION INSTALLATION 4. Use a template to drill the holes for the bracket. Install 5. Fasten bracket into the pre-drilled holes. 8. Insert soap container 1.5 or 3 L. Confirm the container is bracket close to Soap/Foam Tap; behind a wall, in a placed correctly to activate the dispenser. -
Page 5: Installation Height
INSTALLATION HEIGHT CLEANING AND MAINTENANCE Routine cleaning and maintenance is recommended. IMPORTANT! • Ensure easy access to maintenance and cleaning of the unit. REFILL OF SOAP RESERVOIR Sensor Nozzle • It is recommended to install a • Remove soap reservoir and pump unit from the control box power switch to the soap dispenser •... -
Page 6: Calibration Of Sensor Range
Ensure exit nozzle, hose and pump are not clogged. • Ensure that soap meets specified viscosity range: • The calibration setup has completed with the new distance when it starts blinking SOAPTAP 378 viscosity 1cP - 3000cP. green again. FOAMTAP 382 viscosity 1cP. Soap dispenser is malfunc- •... -
Page 7: Parts List
PARTS LIST No. Description TAP wall-mounted End piece LED circuit board Holder for LED circuit board Sensor and nozzle silicone liner Sensor and holder for nozzle (lower part) Holder for nozzle (upper part) Bushing Ø34 mm with thread Rubber gasket for bushing Disc Gasket big Tube/nozzle connecting link... - Page 9 DAN DRYER A/S Alsikevej 8 DK - 8920 Randers NV Tel: +45 8641 5711 Email: info@dandryer.dk dandryer.com...
Need help?
Do you have a question about the SOAPTAP 378 and is the answer not in the manual?
Questions and answers