Summary of Contents for Flash Furniture BL-X-5M-D-GG
Page 1
To help prevent furniture from tipping over it must be permanently attached to the wall. Anti-Tip Safety Wall Straps suitable for the unit weight and wall materials (if not included) should be purchased and installed BL-X-5M-D-GG/BL-X-5M-D-DKGY-GG/BL-X-5M-D-WH-GG/BL-X-5M-D-RED-GG/BL-X-5M-D-BLUE-GG/BL-X-5M-D-BK-LEA-GG...
Page 4
STEP 1: Lay Base (Part 1) upside down on a smooth, clean surface. Insert (5) casters (Part 8) into the base as shown in diagram. STEP 2: Carefully turn over the assembled base from step 1. Insert the Cylinder Column(Part 2) as shown.then take off the Cylinder Column Cap.
Page 5
until fully tightened. Left Arm (Part 6) Right Arm (Part 7) (Part 5) using (4) M6x25mm Bolts (Part A). (Part A) (Part E) NOTE: DO NOT CROSS THREAD SCREWS. If screws start to tighten before parts are securely together, remove screw and try again.
Page 6
(Part F) (Part G) (Part 6) (Part 7) (Part 6) (Part 7) (Part 4) (4) M6x35mm Bolts (Part C) and (4) Flat Washers (Part D). (Part C) (Part E) NOTE: DO NOT CROSS THREAD SCREWS. If screws start to tighten before parts are securely together, remove screw and try again.
Page 7
(Part 4) using (4) M6x40mm Bolts (Part B) (Part B) (Part E) NOTE: DO NOT CROSS THREAD SCREWS. If screws start to tighten before parts are securely together, remove screw and try again.