Advertisement
WARNING! Ensure the light is disconnected from the mains power supply before attempting any of the following.
!
2.3.
BULB CHANGING.
WARNING! Disconnect the light from the mains power supply and allow the light to cool before attempting to touch the unit.
!
DO NOT touch the new halogen bulb as the natural oil from your fingers will shorten the bulb life. Handle with a dry, clean cloth only.
2.3.1.
Loosen the screw on the top of the front cover (fig 8.A) and undo allowing the front cover to open. Check to ensure the screw is retained in the front cover tab (3) by the washer.
2.3.2.
Remove the old bulb and discard. Hold the new bulb in a clean cloth and insert it accordingly. (Always use the correct rated bulb fig 8.1).
2.3.3.
Check that the weather seal is correctly located in the light's rim (4) and the washer is on the securing crew and close the font cover. Seal by tightening the securing screw.
2.4.
GENERAL
Use only original Sealey parts for repair or replacement of parts. Repairs must only be undertaken by a qualified electrician.
Clean the light with a dry, dust-free cloth. DO NOT use solvents, or abrasives to clean the light.
Avoid touching the glass shield (fig 8.2) as handling may reduce its serviceable life and cause the glass to crack. If necessary clean the shield (when cold) with alcohol and a soft
cloth. If the glass is damaged, replace it immediately. Use genuine Sealey replacement glass DO NOT use other glass, and DO NOT use the light without the glass shield.
Although weather proof the light must not be stored wet. Should the unit become wet, unplug from mains, wipe dry and store accordingly.
DO NOT use the light without the weather seals intact.
fig 8.
Specifications:
Power . . . . . . . . . . .230Volt .
Bulb . . . . . . . . . . . . .500Watt Halogen tube.
Detection angle . . . .120
Detection range . . . .12m. (adjustable).
Time delay . . . . . . . .6 seconds to 20 minutes (adjustable).
Light sensitivity . . . . .30 Lux (adjustable).
Declaration of Conformity We, the sole importer into the UK, declare that the product listed below is in conformity with the following EEC
standards and directives.
FLOODLIGHT MODEL MD520C
93/68/EEC CE Marking Directive
2006/95/EC Low Voltage Directive
2004/108/EC EMC Directive
NOTE:
It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this equipment
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: Call us for a copy of our latest catalogue on 01284 757525 and leave your full name and address including your postcode.
01284 757500
(Fan shape).
O
For Jack Sealey Ltd. Sole importer into the UK of Sealey Power Products.
01284 703534
The construction file for this product is held by the Manufacturer
and may be inspected on request by contacting Jack Sealey Ltd
Signed by Mark Sweetman
Sole UK Distributor
Sealey Group,
Bury St. Edmunds, Suffolk.
E-mail: sales@sealey.co.uk
1st October 2007
MD520C - 2 - 10/10/07
Advertisement
