Related Manuals for Neilsen CT3321
Summary of Contents for Neilsen CT3321
- Page 1 SPRAY GUN CT3321 ORIGINAL INSTRUCTIONS Cannon Tools Limited Address: 20 Station Road, Rowley Regis, West Midlands, B65 0JU.U.K. SAVE THESE INSTRUCTIONS AND PRECAUTIONS. READ ALL PRECAUTONS AND INSTRUCTIONS BEFORE USE.
-
Page 2: Ec Declaration Of Conformity
In case of alteration of the machine, not agreed upon by us, this declaration will lose its validity. Product description: SPRAY GUN Model: CT3321 Applicable EC Directives: EC Machinery Directive 2006/42/EC Harmonized standards EN ISO 12100, EN 1953 20 Station Road, Rowley Regis, West Midlands, B65 0JU.U.K. -
Page 3: Safety Warnings Symbols
1. SAFETY WARNINGS SYMBOLS In this manual and/or on the machine the following symbols are used: Denotes risk of personal injury, loss of life or damage to the tool in case of non-observance of the instructions in this manual. Wear hearing protection. Wear safety goggles. -
Page 4: Specification
DO NOT point spray gun at yourself, other persons or animals. DO NOT direct air from the air hose at yourself, other persons or animals. DO NOT carry the spray gun by the hose, or yank the hose from the air supply. ... -
Page 5: Operation And Use
4. ASSEMBLY Carefully remove everything from the packaging and compare it against the contents list. If anything appears to be missing please contact the place of purchase. ATTACHING AN AIR LINE COUPLING (Fig.1): After purchasing the spray gun and before initial use an air line coupling must be fitted that is compatible with your compressor's trailing hose. - Page 6 SPRAY GUN SETUP - AIR CONTROL (Fig.4): The air control (F) regulates the volume of air passing through the gun. As the air passes out through the diffuser horns (E), it mixes with the paint being sprayed. This causes the paint to breakdown in to tiny individual droplets [atomization].
-
Page 7: Maintenance
7.If the shape of the spray pattern differs from the image (Fig.6) refer to the troubleshooting section of this document before proceeding. If the shape, size and distribution of the spray droplets on the second test are largely uneven, it would suggest the atomization of the material is insufficient. - Page 8 holes with the nozzle brush. 4. Carefully undo the paint control to release the spring tension on the needle. Store the control cap and spring to one side. Pull the trigger once and then with draw the needle. Immerse the needle and gun body in the bath to make sure all remaining paint is removed. 5.
-
Page 9: Troubleshooting
7. TROUBLESHOOTING Problem Possible Causes Suggested Remedy 1.Too much paint entering air 1.Decrease paint flow or reduce the nozzle to Spray size generally uneven flow. the next size down. due to poor atomization. 2. Insufficient air hitting paint 2.Increase air flow on the spray gun's air control. flow. - Page 10 8. DISPOSAL At the end of the product's working life, or when it can no longer be repaired, ensure that it is disposed of according to national regulations. In all circumstances: Do not abandon in the environment. Always read the literature supplied with the paint to ensure it is compatible with the equipment and any other paint material that you intend using.