MCOHome MH9-CO2-WD User Manual

MCOHome CO2 Monitor is an air quality controller which compatible with Z-Wave
technology, it is mainly used to monitor CO2 concentration in industrial, agricultural, and
residence environment, while monitoring the indoor temperature, humidity and VOC air quality.
Device can be included into any Z-Wave network, and is compatible with any other Z-Wave
certified devices.
 Power Supply：DC12V
 CO2 display range: 0-2000ppm
 Default threshold:1000ppm (adjustable)
 Temperature range：-9.0～50 ℃
Humidity range: 0%～99%RH

 Installation: Wall-mounted (Vertical)
To protect yourself and others from danger and to protect the device from damage, please read the
safety information before using it.
Important!
 A qualified electrician with the understanding of wiring diagrams and knowledge of electrical
safety should complete installation following the instructions.

Before installation, please confirm the real voltage complying with the device's specification.
Cut off any power supply to secure the safety of people and device.
 During installation, protect the device from any physical damage by dropping or bumping. If
happens, please contact the supplier for maintenance.
 Keep the device away from acid-base and other corrosive solids, liquids, gases, to avoid
damage.
 Avoid overexertion during operation, to protect device from mechanical damage.
 Read all instructions and documentation and save for future reference.
Location:
Device is suggested to be installed indoor, a place with around 1.5m height above the floor
where represents the average CO2 concentration. It should be away from direct sunlight, any
cover, or any heat source, to avoid false signal for temperature control.
MCOHome Technology Co., Ltd
www.mcohome.com
CO2 Monitor
CO2 Monitor
MH9-CO2-WD

Introduction

Specification

 Work environment:-10~+8 ℃ 0-90%RH
(Non-condensation)
 Dimension：90* 130*28mm
 Hole Pitch：60mm or 82mm
Housing: Tempered glass+ PC Alloy


Safety Information

Installation & Wiring
1
User Manual