GREISINGER GMH 5550 Short Manual

Short Manual GMH 5550 Data logger
2 logger functions: cyclic and manual logger
The adjustments are done as described in "Configuration", but go to sub-menu "SEt LoGG" instead of "SEt LoGG". The
submenu contains the following parameters:
Attention: Menu can be only called if logger not active and no logger data stored!
Menu Parameter
Set Logger: Settings for logger function
1 Manual Recording („Func-Stor")
a) Save measured value manually:
Press shortly: data set is saved ("St. XX" is displayed shortly, XX = data set number)
Input of measuring point "L-Id": Number between 0...32768
or
Confirm input with "enter"
If logger storage is full, display will show:
b) Read manual recordings:
Press for 2s: display shows (only if data sets are stored):
Press shortly: change between measuring values, measuring point and date+time of the data set
Change between different data sets
or
End display of recordings
Value Description
or
Selection of logger function
CYCL Cyclic: automatic recording with adjustable cycle time
Store: manual recording with keypress "store"
Stor
oFF Logger deactivated
0:01... 60:00 Cycle time in [minutes:seconds] (for cyclic logger)
H80.0.01.6HC-02