Poulan Pro PL3314 Instruction Manual

:$51,1* 5HDG DQG IROORZ DOO 6DIHW\ 5XOHV DQG
2SHUDWLQJ ,QVWUXFWLRQV EHIRUH XVLQJ WKLV SURGXFW
)DLOXUH WR GR VR FDQ UHVXOW LQ VHULRXV LQMXU\
Quick-Start Guide
Mix 2.6 oz. of full synthetic 2-Cycle Oil
with 1 gallon of fresh seasonal gasoline
for a 50:1 mixture. Shake well. Pour into
fuel tank.
CAUTION: Do not use alternate fuels such as ethanol blends
above 10% by volume (E-15, E-85) or any methanol blended fuel.
Place right foot in rear handle as shown. Using
right hand, pull starter rope sharply until
machine attempts to start, or a maximum of 5
times.
114017395 Rev. C 2018-08-20
Add bar and chain oil to oil tank until
full.
Make sure chain brake is locked by
pushing forward on handguard.
Slowly press primer (air purge) bulb
10 times.
Pull blue choke lever out fully.
Push blue choke lever to half choke
position.
NOTE: In temperatures above 90°F
(32°C), push blue choke lever
completely in.
Instruction Manual
PL3314 / PL3816
NOTE: Your product may differ slightly from the item shown.
Pull starter rope until engine starts.
Allow engine to warm up for 30 seconds.
Starting a Warm Engine
+
NOTE: If the product does not restart, the problem could be
overheated fuel.
To fix this problem, try the following procedure:
1. Set the product in a cool area away from direct sunlight.
2. Allow the product to cool for at least 20 minutes.
3. Press primer (air purge) bulb repeatedly for 10-15 seconds.
4. Follow the cold starting procedure.
Repeat this procedure if the problem still exists.
NOTE: Always use fresh seasonal fuel and shorten operation
time during unseasonably warm weather.
IMPORTANT:
• Never let your saw chain come in contact with soil/dirt during
operation. This will completely dull your chain and will require
installation of a new chain.
• Check your chain tension prior to each time you start the
chainsaw. Check tension on a new chain after the first 15
minutes of operation. See the manual for chain tensioning
instructions.
Make sure chain brake is unlocked by
pulling back on handguard.
Squeeze throttle trigger to set normal
idle. Your chainsaw is now ready for
use.
Press red switch to STOP position when
finished using saw.
+
+
SASA242OP