Detecto APSWIFI Installation And Setup Manual page 8

NETWORK CONFIGURATION, CONT.
Reset to Defaults
ATTENTION! OBSERVE PRECAUTIONS FOR HANDLING ELECTROSTATIC
SENSITIVE DEVICES.
In the event that you change the network settings in such a way that you can no longer
access the APSWIFI or the APSWIFI configuration web page, a jumper has been
provided (J1 DEFAULT) to reset the network configuration to the initial factory defaults.
To reset the APSWIFI to defaults, set the jumper in the shorted position and apply
power to the scale. You should see the DEFAULT LED (D3) light up while the APSWIFI
is in the process of resetting the configuration. When the reset to defaults is complete
you should see the LED flash 5 times and then go out when it is complete.
NOTE: To gain access to the DEFAUILTS jumper, loosen the 2 screws shown and
remove the lid.
It is necessary to completely remove power and re-apply power to ensure that the
default settings have taken effect.
This means that it is very important that the DEFAULTS jumper NOT be left in place on
the board for normal operation and should only be used if trying to recover a module
with incorrect settings.
At this point, the APSWIFI should continue with normal operation using the default
configuration.
NOTE: The DEFAULTS jumper will launch the configuration web page if set briefly after
power up.
4
8527-0570-0M Rev C • APSWIFI Installation and Setup
J1
DEFAULT
LED D3