Advertisement
DC POWER PORT CONNECTION
8
Required Equipment
1. From Packet 700-59066-0003, disassemble the connector's compo-
nents (cap, seal, shell, terminals and body) as follows:
2. Prepare the power cable by stripping the outer sheath on 0.7-0.8 inch
and remove the white insulation material. Note that the seal has a
clamping range of 6.0 mm ± 2.0 mm.
2. Strip each wire insulation to 0.2 inch and crimp the wire terminals onto
both wire ends.
3. Thread the cable with terminals through the cap, seal and shell, then
insert the terminals in the body until they click in place as follows. Re-
fer to next step for properly locating each wire in the body.
1. Insert each wire terminal in its designated hole as follows:
Key
Red wire here
Black wire here
DC POWER PORT CONNECTION (CONTINUED)
9
6. Insert the body into the shell until seated, slide the seal into the shell,
and tighten the cap onto the shell firmly until seated to ensure a good
seal as follows:
7.
The connector is now ready for installation onto the radio. Line up the
white arrows and push the connector onto the mating DC Power Con-
nector on the radio until it clicks in place. To remove the connector
from the radio, rotate the connector end counter clockwise and pull.
SFP PORT CONNECTION TO RADIO
10
Required Equipment
1. From packets 400-59021-0001 and 500-12314-0026, slide the O-Ring on-
to the reducer.
2. From packet 500-57007-0005, disassemble Gland M20. Discard the red
dust cap.
3. Use a fiber optic cable matching the ordered SFP. Thread the fiber op-
tic cable through all components of Gland M20 (cap, seal, body and
washer), and the reducer.The gland seal's clamping range is 2.7 mm ±
0.3 mm.
4. For properly inserting the cable through the seal, push down each wire
through each slit in the seal.
5. Once the SFP module is installed in the radio, insert the fiber optic ca-
ble's end in the radio's SFP port until hearing a click.
6. Screw-in the reducer with O-Ring onto the Radio until firmly seated.
7. Screw-in the body and washer onto the reducer until firmly seated.
8. Slide the seal into the body, then tighten the cap onto the body until
firmly seated. Wrap the final assembly in self-sealing tape.
Advertisement
