EKT UNIVERSAL 908 Programing Manual

FOR TV-VRC-AUX-SAT:
Manual Programing:
1-put batteries in the control and turn on the TV or VRC or AUX
or SAT and point the control at it
2-look at the name of the TV or VRC or AUX or SAT in the codes
table and see its code
3-press and hold the device button you want ex: TV or VRC or
AUX or SAT until the indicator glows and then start flashing
4-enter the code you need the light will go off
5-press (POWER) and try the control
Auto Programing:
1-put batteries in the control and turn on the TV or VRC or AUX
or SAT and point the control at it
2-press and hold the device button you want ex: TV or VRC or
AUX or SAT until the indicator glows and then start flashing
3-press (POWER) the indicator will always glow
4-press (UP) many times one by one until the device off when device
(OK)
turn off press immediately
Note: you have to press (OK) directly when device turn off
try the control if it did not work good repeat the operation again
5-
COPY Programing:
1-put batteries in the control and turn on the TV or VRC or AUX or SAT and point the control at
it
2-press and hold the device button you want ex: TV or VRC or AUX or SAT until the indicator
glows and then start flashing
3-enter the following code: 990 the indicator turn off
4-press number 1 and count the blinks and write it
press number 2 and count the blinks and write it
press number 3 and count the blinks and write it
press number 4 and count the blinks and write it
5-do the manual programming but enter the code you wrote down
6- try the control
UNIVERSAL 908