Kathrein ESO 99 S Manual

ESO 99 S 237500017
Weather-based temperature controller for heating of
reflectors and feed system holders
About these instructions
This document is part of the product. These instructions
describe how to install and connect the ESO 99 S temperature
controller.
▶ Do not install and use the device until you have read and
understood this document.
▶ Keep this document for reference throughout the life of the
device. Pass this document on to any subsequent owners
and users.
The latest version of these instructions for use can be found on
our website: www.kathrein-ds.com
Features
The ESO 99 S is a temperature controller for ESO 120/124/180 H
and ESO 124/180 HL reflector heaters and ESO 126 and ESO 129
feed system holders. It prevents snow, ice and frost building up
on the reflector surface of the antennas:
• Automatic activation of the heating when the outside temper-
ature falls below 4° C and there is snow, ice, frost or water on
the reflector
• Electronic two-point controller with adjustable temperature
threshold for the heating pad
With fastening strap for mast installation
•
• Excess temperature switch-off
• Less than 25% energy consumption compared to ESO 97 S
and ESO 97 SL controllers
Transport and storage
▶ If possible, transport and store the temperature controller in
the original packaging.
▶ Store the temperature controller in a dry location and protect
it against mechanical damage.
Items supplied
• 1 x Controller with mounting plate
• 1 x Sensor assembly
• 1 x Earth strap clamp
• 1 x Earth cable
• 2 x Straps for mast diameter 70 - 90 mm
• 10 x Cable ties 360 mm long
• 4 x Caps M16
• 1 x Cable gland M32 x 1.5
• English instructions for use
1 / 12