Tool Operation Check - Craftsman CMPBN18SB Instruction Manual

English
Fig. E
5. Continue pushing until magazine release lever
is engaged.
Fig. F
Loading Fasteners CMPFN16SB (Fig. G–I)
1. Disconnect the tool from the air supply.
2. Pull follower 8 back until it latches.
Fig. G
3. Insert nails into track of magazine
6
4. Press pusher release
Sequential Trip Operation
This tool is supplied with a sequential trip trigger installed.
The SEQUENTIAL TRIP contains a contact trip that operates
in conjunction with the trigger to drive a fastener. To
operate a sequential trip tool, first position the contact
trip on the work surface WITHOUT PULLING THE TRIGGER.
Depress the contact trip and then pull the trigger to drive a
fastener. As long as the contact trip is contacting the work
and is held depressed, the tool will drive a fastener each
time the trigger is depressed. If the contact trip is allowed
to leave the work surface, the sequence described above
must be repeated to drive another fastener.
8

Tool Operation Check


1. Press the contact trip against the work surface, without
2. Hold the tool off the work surface and pull the trigger.
5 .
3. Pull the trigger and press the contact trip against the
4. With finger off the trigger, press the contact trip
Fig. H
4 to disengage follower.
Fig. I
CAUTION: Remove all fasteners from tool before
performing tool operation check.
touching the trigger. THE TOOL MUST NOT CYCLE.
THE TOOL MUST NOT CYCLE. Release the trigger. The
trigger must return to the trigger stop on the frame.
work surface. THE TOOL MUST NOT CYCLE.
against the work surface. Pull the trigger. THE TOOL
MUST CYCLE.
5
4