Sanwa Tubo Instruction Manual

Bath Accessories
Tubo
Instruction Manual
(with warranty card)
Thank you for purchasing this Sanwa Company product.
Please be sure to read this instruction manual to use this product safely.
1
1

Name of parts

◎Tubo
●Towel ring / Paper holder
Wall-mount washer
Wall-mount screw
Washer
* Use the resin plug when the wall may not be strong enough.
●Towel bar
Wall-mount washer
Wall-mount screw
* Use the resin plug when the wall may not be strong enough.
EN-03-TUB01T-00
Resin plug
Main unit
Main unit fixing screw
Resin plug
Main unit
Main unit fixing screw
●Safety Precautions
Observe the following precautions to prevent injury and
property damage.
Death or serious injury can result from failing to observe the following items:
WARNING
Do not disassemble or alter.
This may result in an accident.
If the installation surface is thin, apply
at least 30mm-thick reinforcement ma-
terial before installation.
Doing so may result in the product breaking or
someone being injured.
Serious injury or property damage may result from failing to observe the following:
CAUTION
Do not hang any articles of value or
fragile items on the product.
Otherwise it may fall, leading to injury.
Do not lean on or stand on the prod-
uct.
Otherwise it may fall and result in the product
breaking or someone being injured.
Do not install the product on a wall
without backing, tiles with no fixing by
plugs or concrete surfaces.
Otherwise it may fall and result in the product
breaking or someone being injured.
1
2

Care Procedures

<Normal care>
Wipe the product with a damp cloth or sponge and then with a dry cloth.
* Do not leave water droplets as this may leave water scales.
<When cleaning>
❶ Remove dirt with a cloth or sponge with mild detergent.
❷ Wipe off the detergent with a damp cloth and then with a dry cloth.
○ Do not use any steel or nylon wool, etc.
(This may scratch the product surface.)
○ Do not use organic solvents such as alcohol and thinner, acidic/alkaline detergent or
cleanser.
(It may result in discoloration or deterioration of the product.)
1
3

Check list before installation

<Precautions before installation>
● Unpack the product and check that there is no damage to any of its external surfaces.
* Damage discovered after installation is not covered by the warranty.
<Check list before installation>
* Use at least 12mm-thick plywood as a basis for the installation surface.
* If the wall is thin, apply at least 30mm-thick reinforcement material before installation.
* If the installation surface is a concrete bed, use supplied or commercially available plugs
for installation onto concrete.
PROHIBITED REQUIRED ATTENTION
Precautions are classified into categories using the symbols above.
Use at least 12mm-thick plywood as a
basis for the installation surface.
Otherwise the product may fall, leading to injury.
If you install the product to any
frame such as a concrete bed, use
the supplied concrete plug or a
commercially available concrete
plug to secure it.
Otherwise it may fall, leading to injury.
The screws used for the product
are sharp. Please keep them in a
safe place.
Otherwise it may result in injury. Especially,
keep them away from children.
Be sure to wear work gloves during
installation and adjustment.
Otherwise it may result in injury.