Led Display - ProBreeze PB-KS01 Instruction Manual

LED DISPLAY

― ―
•
- Weight mode
•
- Water mode
•
- Milk mode
•
- Zero weight
•
- Negative value
•
- Tare weight
•
- Volume unit (fluid ounce)
•
- Weight unit (pound:ounce)
•
- Volume unit (millilitre)
•
- Weight unit (gram)
OPERATING INSTRUCTIONS
― ―
Activating Batteries
1. Turn the scale over and place on a dry
and flat surface.
2. Pull the plastic tab out from the battery
compartment.
Replacing Batteries
1. Carefully remove the battery cover on
the underside of the scale.
2. Insert 3 x 1.5V AAA batteries into the
compartment as per the directions
indicated.
3. After inserting the batteries, replace the
battery cover.
3 | English
Weighing/Volume Measuring
1. Place the scale on a solid and level
surface.
2. Press button to turn on.
3. Press button to set the weighing
mode when the LED display shows "0".
4. Place your weighing receptacle on the
scale if required, the LED display will
show the weight of the receptable.
5. Press button to reset the weight to
zero.
6. Load the weighing object on the scale
(or pour liquid into the container) to start
weighing. The LED display will show the
weight/volume reading.
Note: Press
button to convert the
mode or unit after the scale is turned on.
Zero Or Tare
Zero or tare can be used to weigh different
loads cumulatively without removing the
loads from the scale.
•
ZERO MODE: If the total loaded weight
is below 200g, the symbol
weight) will show. Once a weight as
been loaded onto the scale, you can
press to reset the LED display to
"0" before adding the next load. This
can be used repeatedly.
TARE MODE: When the total loaded
weight is more than 200g, the symbol
(tare weight) will show. In TARE mode
you can reset the LED to ZERO and can
also track the cumulative total of the
different loads being weighed. To do this:
Add the first load to the scale and press
. This LED display will reset to "0".
Press again to see the cumulative
(zero