1. Manuals
  2. Brands
  3. Econoco Manuals
  4. Steam Cleaner
  5. SteamButler ST500
  6. Manual

Econoco SteamButler ST500 Manual

Hide thumbs
1
2
3
4
5
6
7
8
Table of Contents

Advertisement

Quick Links

Download this manual
Commercial Garment Steamer
Die Line for new SteamButler
Your Steamer provides clean,
Bleed Line for Artwork
professional results every time!
• Water container holds 3.5 liters,
enough for hours of continuous use.
• No need to empty water from steamer
after each use.
• Eliminates ironing by removing
wrinkles on the hanger.
• Automatic shut-off safety feature.
• Power indicator light.
• Easy-Roll casters make unit portable.
• Stores upright in a small space.
• Hose hangs on its own hook.
• Steamer handle includes snap-on brush.
Model: ST500

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SteamButler ST500 and is the answer not in the manual?

Questions and answers

Summary of Contents for Econoco SteamButler ST500

  • Page 1 Commercial Garment Steamer Die Line for new SteamButler Your Steamer provides clean, Bleed Line for Artwork professional results every time! • Water container holds 3.5 liters, enough for hours of continuous use. • No need to empty water from steamer after each use.

  • Page 2: Safety Reminders

    Safety Reminders • BEFORE PLUGGING IN your steamer, be sure the electrical information on the label on the bottom of the base agrees with your power supply. This is a high wattage appliance. To avoid a circuit overload, DO NOT operate another high wattage appliance on the same circuit at the same time.

  • Page 3: Steamer Assembly

    Steamer Assembly STEP 1 - ATTACH THE VERTICAL ROD • Insert the rod assembly into the threaded base adapter on top of the steamer base and hand tighten knob. • Loosen the telescoping rod assembly knobs and raise upright fully and hand tighten knobs to secure position. •...

  • Page 4: Steamer Operation

    Steamer Operation STEP 1 - PREPARATION FOR USE 1. Set the appliance on the floor and remove the water bottle. 2. Check for sediment or build-up inside the water reservoir. 3. Follow the steps for cleaning and emptying the appliance if water was accidentally left in the water bottle during storage of the unit.
  • Page 5 Steamer Cleaning & Storage STEP 5 - CLEANING AND STORING THE UNIT • Turn the ON/OFF switch to the OFF position. The indicator light will go out. As the appliance cools down, disconnect the plug from the outlet. • Drain the water bottle by removing it and emptying its contents in a sink.

  • Page 6: Operating Notes

    Operating Notes WHILE OPERATING STEAMER... IF THE STEAMER HOSE GURGLES DURING USE... • This is a normal result of condensation collecting inside the hose. Simply lift the control handle upward until the hose is extended to its full height. • The gurgling will disappear when the excess moisture inside the hose has had a chance to drain back into the base.

  • Page 7: Troubleshooting

    Trouble Shooting Below is a chart detailing the most common problems, their causes, and their solutions. Before shipping any appliance to a service center, please check to make sure that the solution is not listed here. PROBLEM CAUSE SOLUTION Steamer is not plugged Plug the appliance in.
  • Page 8 © 2022 Econoco Corporation • www.econoco.com...

Table of Contents