Panda MP Instructions For Use

Panda MP & SP
PUTTING YOUR BRACE ON
1
Loosen the pull handles and place them as shown.
Then, pull the belt ends to extend the belt.
2
Position the brace
so it is centered and
comfortably aligns with
your spine's curve.
4
Pull both handles
forward to tighten
the brace to the desired
compression. Then press
them down on the Velcro
in front.
These instructions contain general guidelines for using and caring for your Panda brace. If your physician's
specific orders differ in any way, those orders must supersede these guidelines.
If you experience pain or swelling while wearing your Panda brace, immediately contact your prescribing
physician.
Your Panda brace is ready to be worn off-the-shelf (OTS). Customization should only be performed by a medical
professional.
3
Holding the left
belt against your
stomach, place the right
belt on the left belt at a
snug compression.
I F
NSTRUCTIONS OR
TAKING YOUR BRACE OFF
1
Lift the pull handles
and place them
behind center on your
right and left sides.
3
Store your Panda brace in a safe place, taking
care that the Velcro hook doesn't stick to other
fabrics.
TIPS FOR WEARING
Wear a cotton t-shirt or similar garment under the
brace.
If you visit the restroom frequently, you might choose
to wear the Panda outside your clothing.
If putting the brace on as suggested is diffi cult for
you, an alternative method is to lay the brace fl at on
the bed and lie face up on top of it. This will make it
easier to tighten.
U
SE
2
Detach the right belt
from the left belt.