Mounting Options - Cisco VCO/4K Manual

Component Description
Carefully remove the door and place it in an area where it will not become damaged.
Step 3
To install the front door:
Grasp the sides of the door and position it so that the bottom is aligned with the studs located at the base
Step 1
of the enclosure.
Step 2 Flip up the two door latches located to the right and left of the lock. Hold the latches in the open position
and push the door toward the system enclosure until it snaps closed. Press the door latches in.
Step 3 Lock the door.
To ensure security, always lock the front door of the enclosure after you have performed
Caution
service procedures.

Mounting Options

The VCO/4K may be installed in an EIA standard cabinet that is 19 inches wide. If the VCO/4K will be
installed in a cabinet or rack, a mounting shelf must be secured to the cabinet/rack and a mounting brace
must be secured to the VCO/4K before it is lifted and placed in the cabinet or rack. Figure 1-5 shows the
mounting brace (one on each side) for the VCO/4K.
Refer to the Cisco VCO/4K Site Preparation Guide for specifications on the mounting brace and shelf.
Refer to the Cisco VCO/4K Hardware Installation Guide for information on attaching the mounting
brace and shelf.
Two rear support holes are located at the base of the each side panel. You have the option of fabricating
and attaching brackets for additional support when mounting the VCO/4K in a cabinet or rack.
Cisco VCO/4K Mechanical Assemblies
1-6
Chapter 1 System Enclosure
78-10334-03