Instruction Manual
Pop-Up Wall Magnetic
4.
Gently lift up the frame, while flipping it over.
8.
Open the bag and take out the magnetic bars.
12.
Attach the print to the frame, by 'hanging'
them on top of the magnetic bars
1.
Open the case and take out the Pop-Up Frame.
5.
Place your hands on the bars as shown
in the picture.
9.
Attach the bars to the frame in vertical rows
Note: keep the two upper magnets free.
13.
Gently 'kick' the bottom to connect it to the frame,
the magnetic strips should cover the bars halfway
2.
Place the frame in front of you with the label
'Frontside Top' facing away from you.
6.
The Pop-Up Frame unfolds as you lift it up further.
10.
Place the bars with the label 'Bottom Bar' on the
bottom of the frame.
14.
Use the bars on both the front- and backside of
the frame for the panels that go around the sides.
3.
Open the frame slightly by pulling
the hinges outwards.
7.
Push the red marks towards each other,
until all magnetic clips are connected .
11.
Place the bars on the frontside, and on
the left- and right side of the backside.
15.
Attach all panels to the frame,
the Pop-Up Magnetic is now ready for use.