Advertisement
Quick Links
Advertisement
Summary of Contents for Precision RAVEN SMARTRAX
- Page 1 SMARTRAX SUPPLEMENT INSTALLATION MANUAL GVM PREDATOR 117-0190-035...
- Page 2 DISCLAIMER While every effort has been made to ensure the accuracy of this document, Raven Industries assumes no responsibility for omissions and errors. Neither is any liability assumed for damages resulting from the use of information contained herein. Raven Industries shall not be held responsible or liable for the effects of atmospheric conditions and sunspot activity on the performance of our products.
- Page 3 RAVEN INDUSTRIES LIMITED WARRANTY WHAT IS COVERED? This warranty covers all defects in workmanship or materials in your Raven Flow Control Product under normal use, maintenance, and service. HOW LONG IS THE COVERAGE PERIOD? This warranty coverage runs for 12 months from the purchase date of your Raven Flow Control Product.
- Page 4 RAVEN INDUSTRIES FLOW CONTROL DIVISION 205 East Sixth Street - P.O. Box 5107 - Sioux Falls, South Dakota 57117-5107 E-mail: fcdinfo@ravenind.com www.ravenprecision.com Toll-free: 800-243-5435 - Fax: 605-331-0426 Supplement Installation Manual, GVM Predator #016-0190-035 Rev A 07/04...
-
Page 5: Table Of Contents
016-0190-035 TABLE OF CONTENTS 07/04 MOUNTING THE UNIVERSAL BRACKET AND STEERING POSITION SENSOR ......2 MOUNTING THE HYDRAULIC VALVE AND PRESSURE SWITCH ..........2 HOSE CONNECTIONS AND ROUTING .................... 3 PRESSURE HOSE ......................... 4 EXCESS FLOW HOSE ......................4 TANK PORT TO ORBITAL HOSE ..................5 A-PORT TO LEFT STEER HOSE .................. -
Page 6: Mounting The Universal Bracket And Steering Position Sensor
MOUNTING THE UNIVERSAL BRACKET and STEERING POSITION SENSOR Attach the universal mounting bracket on the right side of the machine using the provided 1/2” hex- head bolts. Drill holes to fit the mounting bracket pattern and the air filter support hole pattern in a steel plate. -
Page 7: Hose Connections And Routing
HOSE CONNECTIONS and ROUTING New hoses should be run so they follow the approximate routing of the old hoses. This keeps crops and debris from dragging on the hoses during operation. Run the new hoses from the valve upward using supplied 90-degree elbow fittings and route the hoses underneath the cab toward the steering orbital. -
Page 8: Pressure Hose
PRESSURE HOSE Remove the existing pump to orbital hose and connect the provided pressure line with the 90-degree elbow end to the pump. Route the hose along the frame underneath the cab to the P-port on the hydraulic valve. Attach a 3/4” jic 90-degree adapter fitting to the P-port on the hydraulic valve and connect to the Pressure hose. -
Page 9: Tank Port To Orbital Hose
Left Steer hose with tee and elbow fitting Boom lock hose FIGURE 6 Right steer hose with tee and elbow fitting TANK PORT TO ORBITAL HOSE Disconnect the existing line from the orbital to the tank. On the orbital, attach a tee fitting and a 9/16” JIC fitting end of the Tank Port to Orbital hose.