Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Zünd AKI 2
- Page 1 AKI 2 w00018...
-
Page 2: Table Of Contents
Product description ....4 2.1 AKI 2 ........4 Safety requirements . -
Page 3: General
Instruction Manual General AKI 2 1 General General information The AKI 2 (Automatic Knife Initialisation) is used for automatic knife initialisation of following uses of tool: – Implementation case with various knives – EOT-40 – EOT-3 – POT-40 (Plus) – POT-40va –... -
Page 4: Product Description
(Fig. 1) AKI 2 1 AKI 2 4 Initialisation cut/groove 2 Plug park station - AKI2 5 Positioning handle 3 AKI 2 Park station 6 Positioning aid 3 Safety requirements Important! These safety requirements and information are simple tool-specific enhancements to the Safety requirements section of the Plotter Operating Manual. -
Page 5: Proper Use
– Failure to react to signs of abrasion and damage – Deactivation of safely equipment Danger due to improper use – Breakages of tool inserts – Damage of equipment – cutting injuries due to sharp cuts AKI 2 6. July 2006, muj, _1... -
Page 6: Operation
(1.5 mm) Important With OFFSET T1 - T4 the operating position of the knife is set, if the values for POS DOWN = 0 and Z-OFFSET = 0 are set. AKI 2 6. July 2006, muj, _1... -
Page 7: Menu Tree
118521 - 4 OFFSET1 T1 - 4 Setting of the Offset for each module in mm (inch) 11853 - 6 AKI TOOL 1 - 4 AKI for each individual module can be switched on and off AKI 2 6. July 2006, muj, _1... -
Page 8: Insert
Instruction Manual Operation Insert w00024 (Fig. 4) Insert AKI2 • Put AKI2 in the park station • Insert AKI2 The AKI2 is now ready for operation. AKI 2 6. July 2006, muj, _1... -
Page 9: Height Adjustment
Screw the set screw anticlockwise • Put the AKI2 flat on the cutting base (Fig. 5, Pos.2) • Set the set screw (Fig. 5, Pos.4) (lower clockwise, lift anticlockwise) that it touches the table top AKI 2 6. July 2006, muj, _1... -
Page 10: Automatic Initialisation
B Press AKI2 on the table top with the positioning handle. This ensures that the AKI2 is lying flat on the table surface. C After starting the initialisation (11851) the active module is positioned automatically above the initialisation groove of the AKI2. AKI 2 6. July 2006, muj, _1... -
Page 11: Initialisation
Check before the automatic initialisation whether the AKI2 is anchored correctly in the positioning aid. w00022 (Fig. 7) AKI2 place of deposit • After the automatic initialisation place the AKI2 on the park station. AKI 2 6. July 2006, muj, _1... -
Page 12: Messages
At a confirmation with ENT the manual initialisation is You are sure performed. The function AKI is switched to OFF for the current tool CE/ESC for Aborting/ (11853 - 11856). It is cancelled with ESC/CE. cancelling Continue with ENT AKI 2 6. July 2006, muj, _1...
Need help?
Do you have a question about the AKI 2 and is the answer not in the manual?
Questions and answers