Toshiba DKT2001 Technical Bulletin page 6

Program 39 Flexible Button Assignments
Program 39 Overview
Program 39 assigns features to the flexible buttons for individual telephones in the system.
Several types of buttons can be assigned with this program, including:
Feature
[PDNs], [SDNs] and [PhDNs] – Message Waiting buttons can be assigned to [PhDNs]
Alert Signal (Buzz key)
Feature Buttons Assignments
You can assign commonly used telephone features to any flexible button (see Table 3-1).
Button assignments can be different for individual telephones. Telephone users can also assign
flexible buttons if their COS and/or if programming permits the feature on their telephone.
Important!
DKAdmin programs a Pause on buttons 11~20 on 10-key telephones.


The
button. Do not program CO lines or secondary line appearances onto button 01 or in any
other position. Since the system assigns CO lines 01~17 by default, be sure to remove any
CO line appearances by programming them as Station Speed Dial buttons (code
If the
Note
 


and
To assign features to flexible buttons
1. Complete Program 38 before Program 39. Initialized data assigns the keystrip pattern
associated with Code 31 from Program 38.
2. Use "Program 39 Flexible Button Assignments" on Page 3-113 to indicate feature buttons.
Use the programming sequence on the following page to perform the following steps.
3. Program the port number or enter a range of port numbers.
4. Press the button that will be associated with the feature.
5. Enter the feature code.
6. Repeat this procedure until all feature buttons have been assigned.
Table 3-1 Feature Button Codes for Digital and Electronic Telephones
Button Function
Account Code Account Code or ACCNT
Alarm Alarm Reset or ALRM
Alert Signaling (see following pages)
All Call Voice Page All Call Page or AC
Automatic Busy Redial Auto Busy Redial or ABR
Automatic Callback Busy Auto Callback or ACB
Background Music Tel Set Music or BGM
Call Forward All Calls Call Frwd All Calls or CFAC
Call Forward A.C. Fixed Call Frwd to: or CFF
3-114
All manuals and user guides at all-guides.com
button on the DKT2001 is flexible button 01. Only program a [PDN] onto this
   
button is removed, the
button. While on an outside call, the user must press
 
DTMF tones for the duration of the call.
Button Labels Code
450
477
489
470
494
478
487
486


key becomes the
Notes
Allows a Voluntary Account Code entry.
Resets alarm condition system-wide.
Pages up to 120 idle electronic or digital telephones over
Sets ABR of busy outgoing number.
Sets ACB for station recalled by busy line.
Turns BGM ON or OFF through station speaker.
All calls forward to selected station.
Forwards all calls to pre-defined destination. See Program 36.
Strata DK Programming September 1998
System & Station


).
 
 


then to activate the