Hauschen Home SPECTRO Installation & Aftercare Instructions

SPECTRO / HALO
LED LIGHTED MIRROR
INSTALLATION & AFTERCARE INSTRUCTIONS

Electrical Safety Instructions

INSTALLATION has to be made by a qualified / registered electrician. DO NOT attempt to install by yourself as HAUSCHEN HOME will not
be responsible if this product is not installed by a professional.
Important
Read this instruction carefully and refer back to them during installation to ensure that your product is fitted safely and correctly.
Always switch off the electrical supply at the mains during installation and maintenance. It is recommended that the fuse is withdrawn or the
circuit breaker is switched off for the necessary circuit before installation.
Fitting in Bathrooms is subject to the appropriate zone in accordance with IEE Regulations. This product is suitable for zone 2 and outside zones.
IT IS NOT suitable for installation in Zone 0 or Zone 1. It is also not suitable for installation in saunas, steam rooms or shower cubicles. This
product is only suitable for permanent installation. DO NOT connect to a trailing plug and socket outlet. Although this product has an Ingress
Protection rating of IP44 it is only suitable for indoor use. Do not attach the product to surfaces that are damp or otherwise electrically
conductive.
Installation Care & Safety
Wear suitable eye protection when drilling. Take care when using power tools near water - the use of a residual current device (RCD) is
advised. Beware of hidden cables or pipes. Take care if drilling on tiled surfaces in case the drill slips. A piece of masking tape applied to the wall
before marking out the fixing holes will stop the drill from wandering.
DO NOT strike glass components with hard or pointed items.
DO NOT place very hot or very cold items against or in close proximity to glass surfaces unless an adequately thick insulation material is used
to prevent such items coming in contact with the glass.
The nominal thickness of the mirror glass used in this product is 5mm. If the glass becomes chipped or broken replace immediately.
This product should be positioned well away from curtains and other fabrics. Never cover the mirror. This product is heated, we recommend
that it is turned off after use and should never be left on for prolonged periods of time
This product could be dangerous if installed incorrectly.
PLEASE RETAIN THIS INSTRUCTION LEAFLET FOR FUTURE REFERENCE.

Cleaning

WHEN THE MIRROR MUST BE CLEANED, IT IS NECESSARY TO SWITCH IT OFF FIRSTLY!
DO NOT use abrasives or solvents when cleaning this product. Wipe off all water spillages as soon as possible using a soft, damp cloth.
DO NOT submerge mirror in water, do not let go of water in the mirror.

Compliance

All electronic components used in this products are UL listed.

Wiring

This product is designed and manufactured in class II category, no need earth connection.
The product need hardwired with the supply cable lead from the wall. Also we provide extra 1.5m U.S. 2-pin plug for easy connection with
exist wall socket.
Lights & Control
The integrated LED light source and system are not support to replaced by consumers, please DO NOT change by yourself.
The lights (and defogger) are controlled by touch sensor on mirror surface to turn on/off and adjust brightness and color temperatures.
Keeping the mirror lights on, then you also could control it on & off by wall switch, if connect with it. The last working condition before
switching off would be kept while turn on again, either brightness level or color temperature.
VER. 4.0 - 05/2019