Indicators On Lcd - PITSOS PSI09VW31 Manual

Function buttons(continued)
13
1
8
ON/OFF
14
9
TEMP
2
SHORT
MODE 10
CUT
FAN
3
SWING
SPEED
11
15
12
4
TIMER
DIRECT
ON
SLEEP TIMER 13
5
FRESH OFF
TURBO LED
14
6 SELF FOLLOW
CLEAN
ME
7
RESET
LOCK
15
TIMER OFF Button
Press this button to initiate the auto-off time
sequence. Each press will increase the
auto-timed setting in 30 minutes increments.
When the setting time displays 10H, each
press will increase the auto-timed setting
60 minutes increments. To cancel the
auto-timed program, simply adjust the
auto-off time to 0.0
LED/FOLLOW ME Button
Disable/Active indoor screen Display. When
,
pushing more than 2 seconds, the FOLLOW
,
ME function will be activated, pushing more
than 2 seconds again to disable.
LOCK Button
When you press the recessed LOCK button,
all current settings are locked in and the
remote controller does not accept any
operation except that of the LOCK. Press
again to cancel the LOCK mode.
NOTE:
Buttons design might be slightly
different from the actual one you
purchased depending on individual
models.
All the functions described above
are accomplished by the indoor unit,
if the indoor unit has no this feature,
there is no corresponding operation
happened when press the relative
button on the remote controller.
7

Indicators on LCD

Transmission Indicator
This transmission indicator lights when remote
controller transmits signals to the indoor unit.
Mode display
Displays the current operation mode. Including
auto(
applicable to cooling only models), fan(
and back to auto(
Temp./Timer display
Displays the t emperature s etting(17 C/62 F~30 C/88 F).
auto cool dry heat fan
When you s et t he o perating m ode to FA N, no tem perature
setting is displayed. And
the ON and OFF settings of the TIMER.
SET TEMP. TIMER ONOFF
Fan speed display
Displays the selected fan speed, AUTO(no display)
and three fan speed levels " " (LOW) "
"
when the operating mode is either AUTO or DRY.
ON/OFF display
sleep follow me lock run
Displayed by pressing the ON/OFF button.
Press the ON/OFF button again to remove.
F
Lock Display
Displayed when LOCK mode is activated.
FOLLOW ME Display
Displayed when FOLLOW ME function is activated.
Sleep Display
Displayed under sleeping operation.
Press the SLEEP button again to remove.
Note:
All indicators shown in the figure are for the purpose
of clear presentation. But during the actual operation
only the relative functional signs are shown on the
display window.
), cool( ), dry( ), heat( ) (Not
)
).
O O
if in the TIMER mode, shows
" (MED)
" (HIGH) can be indicated. The fan speed is AUTO
8
O O