Initialise – Procedure to reset all desk legs to the fully retracted position so that the control box knows where they are. Reference – Any group of desk legs that run in parallel when an Up or Down command is sent to the control box. IC System Example DL11 Strata 360 Troubleshooting Manual...
Page 3
- When the light strip becomes static white, the position is saved. - The display will indicate this saved position with a star and a number of the position. Error codes in Cause CBD6s E53-E64 COLLISION E41-E52 OVERLOAD INITIALISATION Scan QR Code for More Information Strata 360 Troubleshooting Manual...
Page 4
(only possible for “Full version” with “Automatic drive” enabled in the app) 1. Double-tap DPG1C to let desk adjust automatically to first position in direction of double-tap. 2. Simply tap DPG1C once to stop driving of desk between two favourite positions. Strata 360 Troubleshooting Manual...
Page 5
DPG1C up at the same time for 8 seconds until light flashes. 3. Release and DPG1C. Setting lower limit 1. Adjust desk to minimum allowable height. 2. Press and press DPG1C down at the same time for 8 seconds until light flashes. 3. Release and DPG1C. Strata 360 Troubleshooting Manual...
Measure the accurate distance between the floor and the desk-top in centimetres. Hold the 'Bell' & buttons for 5 seconds, when the display begins to blink it is ready to be reset. Tilt the DPG upwards or downwards to increase or decrease the displayed height. Strata 360 Troubleshooting Manual...
Page 10
Burgtec accepts no responsibility for possible errors or inaccuracies in catalogues, brochures, and other material. Burgtec reserves the right to change its products without prior notice. Burgtec cannot guarantee product availability and reserve the right to discontinue the sale of any product. User is responsible for determining the suitability of Burgtec products for a specific application.