Do you have a question about the 7600015 and is the answer not in the manual?
Questions and answers
Summary of Contents for Original Tractor Cabs 7600015
Page 1
# 7600015 CAB For Snapper Turf Cruiser and Trail Cruiser OPERATION - PARTS LIST - ASSEMBLY IMPORTANT ! READ THIS MANUAL CAREFULLY AND KEEP FOR FUTURE REFERENCE CAUTION REMOVE THE VINYL PANELS FOR TRANSPORT IN AN OPEN TRUCK OR TRAILER...
For Replacement Parts and Accessories Contact: Original Tractor Cab Co., Inc. P.O. Box 97 6849 W. Front St. Arlington, IN 46104 Phone 765-663-2214 765-663-2101 Email Sales@originalcab.com Visit us on the web to see our other products. www.originalcab.com Cabs for Lawn Tractors, Garden Tractors, Compact Tractors, Snow Blowers, Utility Vehicles Sunshades for Tractors, Mowers, &...
WARNING This cab is designed to provide foul weather protection only. It does not provide protection from noise, exhaust fumes, chemicals or injury from collision, roll-over, or other accidents. 1. Do not operate machine in confined areas without proper ventilation 2.
Page 4
Carton Contents: Cab # 40226 for Turf & Trail Cruiser KEY# PART# QTY. DESCRIPTION 40228 Foot, RH 40229 Foot, LH 40230 Rear Bracket, RH (short tabs) 40231 Rear Bracket, LH 40148 Front Posts 40086 Front Panel Frame Cross Bar 10750 Rear Post, RH 10751 Rear Post, LH...
Page 5
Step 2; See Figure 2: A. Use Figure 2 to identify all of the steel parts. Figure 2...
Page 6
Step 3; See Figure 3 & 3a: Install Foot Right (1) and Foot Left (2). A. Remove the two bolts that hold the dash to the fenders. B. Insert the right Foot between the dash and fender as shown with the tab leaning forward. C.
Page 7
Step 5; See Figure 5: Install Front Posts (5) and Front Panel Frame Cross Bar (6). A. Use two bolts and nuts to attach the posts to the right and left foot. Tighten just enough to keep the posts upright. B.
Page 8
Step 7; See Figure 7: Install ROPS Brackets (11) and Top Frame (12). Door alignment. A. Place the Rops Brackets on the rops as shown. Insert two 1/4” x 2 3/4” bolts up through the holes. Add nuts. Do not tighten at this time. B.
Page 9
Step 9; See Figure 9: Install Rear Curtain (13). A. Close the snap flaps around the top frame at the back and corners. B. Close the snap flaps over the rear posts and brackets. C. Thoroughly clean the area where the adhesive fastener is to be applied.
Page 10
Step 11; See Figure 11 & 11a: Install Windshield (16) & ABS Plastic Top (15) A. Place the Plastic Top on the top frame. B. Set the bottom lip of the windshield frame on top of front panel vinyl and the front panel frame cross bar.
Need help?
Do you have a question about the 7600015 and is the answer not in the manual?
Questions and answers