Lectric XPremium Owner's Manual page 23

Throttle
The right handlebar features a half-twist throttle.
To operate:
Check that the Pedal Assist (PAS) level is set above 0, then twist the
throttle back slowly to achieve your desired speed and acceleration.
When using throttle use gear 4 or below. This will maximize the bike's
acceleration and top speed while minimizing how quickly the motor
heats up. Using the bike outside of this gear range will heat the motor
faster, potentially causing a temporary drop in performance until
motor cools. See the Motor section on p. 21 for additional information.
Continuous throttle usage will heat the motor faster, potentially
causing a temporary drop in performance until motor cools.
Hydraulic Disc Brakes
Your Lectric eBike is equipped with hydraulic disc brakes.
WARNING!
To prevent serious injury or death:
• ALWAYS apply the right brake lever (rear wheel) before and during
use of the front brake.
• ALWAYS apply even pressure to both brake levers when slowing
down or stopping.
If only the front brake is applied while slowing or stopping quickly,
you may be ejected over the front handlebars.
Before riding, check to ensure brake levers do not touch the handlebars
when fully applied. If either lever touches the handlebars, take your
bicycle to an experienced bicycle mechanic for further adjustment.
To brake the rear wheel:
Pull the right brake lever to activate rear brake.
To brake the front wheel:
Pull the left brake lever to activate front brake.
Disc brake rotors will become hot during use and will stay hot
for a short period after use. To prevent burns, do not touch the
disc rotor right after use.
L E CT R I C E B I K E S.C O M | 602.715.0907 23