Privacy Codes - DeWalt DXFRS300 Instruction Manual

Privacy Codes

Your radio incorporates two advanced coded squelch systems that can help
to reduce interference from other users on any given channel. CTCSS
(Continuous Tone Coded Squelch System) provides 38 privacy codes and
DCS (Digitally Coded Squelch) provides 83 privacy codes. This provides a
total of 121 Privacy Codes. Either system can be used on all channels, but
both systems cannot be used on the same channel at the same time.
For ease of use and reduce interference from other users, the 22 channels of
your radio has been customized, see Channel and Default Privacy Code
Table.
Channel and Default Privacy Code Table
Privacy Code
Channel
Type Number
1 CTCSS 1
2 CTCSS 11
3 CTCSS 22
4 CTCSS 33
5 DCS 1
6 DCS 11
7 DCS 22
8 DCS 33
9 DCS 44
10 DCS 55
11 DCS 66
You can change your radio to a different Privacy Codes for
working with other radio with different privacy code or without
privacy code. See page 8 and 9 for procedures.
7
Privacy Code
Channel
Type Number
12 DCS 77
13 CTCSS 1
14 CTCSS 11
15 CTCSS 22
16 CTCSS 33
17 DCS 1
18 DCS 11
19 DCS 22
20 DCS 33
21 DCS 44
22 DCS 55
Set CTCSS Privacy Codes
To select a CTCSS privacy code:
Mode Button
1. After selecting a channel, press the Mode button until
the CTCSS icon appears and the small numbers next
to the channel number flash on the display.
If DCS is turned on at the channel selected, the
Privacy Code
display will flash the CTCSS icon and "OFF."
To switch from DCS to CTCSS, press the Up or
Down button while the display is flashing
"OFF." The display will then show the small
numbers flashing and you will then be able to
Up/Down Button
proceed to step 2.
2. Press using the Up or Down button to select a privacy
code. You can hold the Up or Down button for fast
advance.
3. When your desired CTCSS privacy code is displayed, choose one of the
following:
a. Press the Mode button to enter the new setting and proceed to other
functions.
b. Press the Talk button to return to Standby mode.
c. Do not press any buttons for 6 seconds to return to Standby mode.
8