Advertisement
4. Install body to wall/ceiling.
5. Insert incoming supply cable through cable gland and connect incoming supply cable to terminal block.
6. Install LED module tray and diffuser to body tighten with screw properly.
"Do not overtighten diffuser fixing screws or damage may occur – recommended torque setting of 4nm"
CAUTIONS:
•
Installation is to be completed by a competent licensed electrician, in accordance with these instructions and relevant
local regulations.
•
Electronic control equipment must not be subjected to high voltages, DO NOT MEGGER between Live and Neutral.
•
All cable/conduit terminations must be installed in accordance with the designated IP rating of this product.
•
Suitable installation fastening methods should be employed to ensure the mounting points are not damaged when
subjected to vibration and or movement.
As is the case with all electronic components, it is advisable to fit appropriate surge protection to final sub circuits.
•
Choose an installation place capable to withstand 10 times the weight of the product to ensure safety.
•
When using glands provided as cord anchorage for flexible cable the cable diameter shall not be less than 8.4 mm
•
and not larger than 12.0 mm.
MAINTENANCE:
The supply must be isolated before opening or accessing the luminaire. Product maintenance is critical to the product designed
performance. The product is to be maintained in accordance with the manufacturer's instructions. For the latest product
maintenance guides please go to www.davislighting.com. Davis Lighting is not responsible for any product not maintained in
accordance with the recommended procedure or intervals. For recommended LAMP / LED maintenance guides, please refer to
the lamp installation guidelines supplied with the lamp product or the nominated lamp manufacturer's website. Products
supplied with visors or covers must not be operate with a damaged visor or cover; it is recommended damaged visors or covers
be replaced by a competent person immediately.
LA-P1352-00
Advertisement
