Rear Panel - Cary Audio Design SLP 03 Owner's Manual

CONTROLS AND DISPLAYS

REAR PANEL

1. BALANCED INPUTS
• Accepts right-channel and left-channel balanced signals from source equipment with
balanced outputs.
• The pin assignments of these XLR-type female input are:
Refer to the operating manuals of your balanced-output line-level sources to verify that
the pin assignments of their output connectors correspond to the SLP 03. If not, wire the
cable so that the appropriate output pin connects to the equivalent input pin.
2. SINGLE-ENDED INPUTS
• Accepts right-channel and left-channel (RCA) inputs from line-level source equipment
such as tuners, CD player or SACD player.
3. CINEMA BYPASS
• Designed to accept the left and right main channel from a surround processor to drive
the left and right amplifier system amplifiers. The proper setting of the SLP 03 volume
level should be set to number 47 on the front display of the SLP 03. The number 47 is
where unity gain occurs. With the SLP 03 set to Cinema Bypass input mode and the
volume at number 47 on the display the processor will now operate through the SLP 03
to control the left and right channels.
4. ANALOG RECORD OUTPUT JACK (RCA UNBALANCED)
• Use these jacks for connection to the right-channel and left-channel tape inputs of your
tape or hard drive based recorder.
5. SINGLE-ENDED MAIN OUTPUTS
• Use these jacks for connection to the power amplifiers.
Pin 1: Signal ground
Pin 2: Signal + (non-inverting)
Pin 3: Signal - (inverting)
Connector ground lug: chassis ground
10