Switching on the unit for the first time The unit has an internal power switch so that it cannot be accidentally switched on and the batteries discharged during transportation. 1. Unscrew the 4 lid screws as indicated and carefully remove the lid. 2.
Always dispose of electronic equipment or batteries in accordance with local regulations. Increasing standby power time Where more than 2-3 hours of standby power is required, an RDC PSU-100 power supply, with an additional external battery, can be connected to the unit as shown below.
- AutoAck No output - C30 acknowledges signal data. - Repeater The RS232/USB port is used as an input to repeat data to the RDC server. The server will distribute the data as per server configuration to other C30's/C20's. Network SIM_PVT RDC private APN SIM.
Roll Back Restores the application to the previous version. Remote Support If enabled, settings and historic system data can be accessed by RDC to render remote support. Request Support Sends unit support data via email to RDC to request assistance.
Page 7
POS NEG IP1 Power switch Unscrew the 4 lid screws and remove the lid from the backup C30 unit. Ensure that the internal power switch is in the off position. Insert the SIM card/s from the live unit into the SIM card holder of the backup unit.
Need help?
Do you have a question about the C30 and is the answer not in the manual?
Questions and answers