Advertisement
Quick Links
Advertisement
Summary of Contents for GSD Kleenair
- Page 1 5hp High-Pressure Blower Assembly & Operations Manual...
- Page 2 Page 2...
- Page 3 Page 3 Table of Contents Introduction Safety Assembly Examples...
- Page 4 Capacity A. The capacities may vary greatly under varying conditions. The following factors play a role in the performance of the KLEENair Vacuum Grain Screener. - Speed/rpm - Amount of foreign matter...
- Page 5 Page 5 Safety Safety Instructions Our foremost concern is your safety and the safety of others associated with this equipment. We want to keep you as a customer. This manual is to help you understand safe operating pro- cedures and some problems which may be encountered by the operator and other personnel. As owner and/or operator, it is your responsibility to know what requirements, hazards and pre- cautions exist, and to inform all personnel associated with the equipment or in the area.
- Page 6 Page 6 Safety Continued Operate Unload Equipment Properly Untrained operators subject themselves and others to SERIOUS IN- JURY or DEATH. NEVER allow untrained personnel to operate this equipment. NEVER work alone. Keep children and other unqualified personnel out of the working ...
- Page 7 Page 7 Safety Continued Prepare for Emergencies Be prepared if fire starts. Keep a first aid kit and fire extinguisher handy. Keep emergency numbers for doctors, ambulance service, hospital and fire department near your telephone Wear Protective Clothing Wear close fitting clothing and safety equipment appropriate to the job. Remove all jewelry.
- Page 8 Page 8 Assembly Assemble 5 hp Blower Kit Remove the outer cover that has the 8” round opening. Remove packing materials and propeller. Remove the propeller housing and rotate to the desired direction that you wish to dis- charge the screenings. If the discharge is already pointing in the desired direction then skip to the next step.
- Page 9 Page 9 Assembly Continued Assemble Suction Hose Slide the 2’ x 6” flex hose about half way onto the 6” x 6” galvanized tube. Fasten in place with 4-1/8—7” hose clamp. (see figure 3) Slide the other end of the 6” x 6” galvanized tube into the 6” side of the 8” to 6” reducer. Fasten in place with a 4-1/8—7”...
- Page 10 Page 10 Assembly Continued Attach the other end of the 2’ x 6” flex hose to either side of the KLEENair hopper. Fasten in place with 4-1/8—7” hose clamp (see figure 6). Attach the red tube cover onto the other side of the hopper.
- Page 11 Page 11 Assembly Continued Completed Assembly Attach tubing (not supplied) to the discharge transition on the blower. 4” galvanized tubing recommended for 1 HP blower 6” galvanized tubing recommended for 3 HP and 5 HP blowers WARNING: Using plastic or PVC tubing will cause static electricity and possible electrocution or fire.
- Page 12 GRAIN SYSTEMS DISTRIBUTION GRAIN SYSTEMS DISTRIBUTION GRAIN SYSTEMS DISTRIBUTION 1104 INDUSTRIAL PARK ROAD 7702 EAST ST RD 356 601 OLD STATE RD 15 ROCK FALLS, ILLINOIS 61071 OTWELL, INDIANA 47564 MILFORD, INDIANA 46542 815-625-2838 812-354-2496 574-831-4120 01-01-2022...
Need help?
Do you have a question about the Kleenair and is the answer not in the manual?
Questions and answers