Specifications - Cary Audio Design CAD 200 Owner's Manual

SPECIFICATIONS ___________________________________________________

This section describes the basic specifications of the CAD 500 MB or CAD 200 power amplifiers at the time
of printing. Specifications are subject to change without notice or obligation. When the following
cautionary terms are used in this manual, these definitions apply:
WARNING
Electrical hazard! Misuse or failure to follow instructions properly may result in personal injury
or death!
CAUTION
No risk or personal injury; however, misuse or failure to follow instructions may result in
damage to equipment.
NOTE
No risk of personal injury or equipment damage; however, misuse or failure to follow
instructions may prevent proper performance of the equipment.
........................................................................................................................................................................................................................
RATED POWER OUTPUT
CAD 500 MB
CAD 200
........................................................................................................................................................................................................................
DAMPING FACTOR
........................................................................................................................................................................................................................
PEAK CURRENT
........................................................................................................................................................................................................................
FREQUENCY RESPONSE
........................................................................................................................................................................................................................
INPUT POWER REQUIREMENTS 117 VAC 50/60 Hz or 234 VAC 50/60 Hz, by market
........................................................................................................................................................................................................................
POWER CONSUMPTION
........................................................................................................................................................................................................................
INPUT IMPEDANCE
........................................................................................................................................................................................................................
OUTPUT IMPEDANCE
........................................................................................................................................................................................................................
GAIN
........................................................................................................................................................................................................................
THD
........................................................................................................................................................................................................................
NOISE
500 watts @ 8 ohms, 1,000 watts @ 4 ohms, Class A/B
200 watts/channel - 8 ohms, Class A/B x 2
350 watts/channel - 4 ohms x 2
>100 @ 8 ohms
CAD 500 MB - 70 amps
CAD 200 - 35 amps
10 to 50 kHz +/-0.1 dB
-3 dB @ 200 kHz
255/155/115/90/125 Watts – Idling with no signal input
2500/1000, All channels, 8-ohm load, full power
44k ohms - Single-ended RCA inputs
91k ohms - Balanced XLR inputs
4 to 16 ohms rated speaker impedance
27 dB
< 0.05 %, 20 Hz-20 kHz
> 100 dB below rated output, A-weighted
6