Summary of Contents for ToolMaster ATP-50
- Page 1 Industrial Series ATP-50 AiR PUNCH & FLANGE TOOL INSTRUCTION MANUAL Code: A088 www.machineryhouse.com.au www.machineryhouse.co.nz www.machineryhouse.com.au www.machineryhouse.co.nz...
- Page 2 4. Do not use this tool for other than its intended cause a hazardous situation. use. If used for other purposes, Toolmaster disclaims any real or implied warranty and 16. Check air hoses for wear, and keep them away holds itself harmless from any injury that may from heat and sharp edges.
- Page 3 Safety Specific For Punch & Flange Tool 1. Do not try to punch or flange material thicker 5. Always remove the tool from air supply and than capacity specified in the specification activate trigger to bleed air-line before making 2. Appropriate footwear must be worn. Shoes any adjustments, changing accessories, or must be fully enclosed. No open-toed shoes. doing any maintenance or service on the tool 3.
- Page 4 Setup Any missing parts or damage should be reported immediately to your Toolmaster distributor. Do not use a damaged tool. Read this instruction manual thoroughly for operation, maintenance and safety instructions. The diagram below is the ideal setup position. The lubricator is optional and if not used, then a few drops of Pneumatic Tool Oil need to be added to the airline connection before operation.
- Page 5 Operating Instructions 1. Disconnect the air tool from the air line. 2. If required, to improve access to the workpiece, the head can be rotated through 360°. To do this, loosen the Head Rotation lock screw and rotate the head. (See Fig.2) 3.
- Page 6 Review the troubleshooting and procedures in this section if a problem develops with your Air Tool. If you are still unable to resolve the problem, then contact your local Toolmaster service centre. If additional help with a procedure is required, then contact you distributor.
Need help?
Do you have a question about the ATP-50 and is the answer not in the manual?
Questions and answers