Advertisement
When working on or with the product, observe the following:
Electrical voltage and current
DANGER
Electrical voltage
Regularly check the electrical equipment of
the product.
Even at low supply voltage the
voltage may rise due to current
regeneration of energy.
Motors which decelerate or slow
down, work similarly to a generator
and hereby release electrical power.
Thus life-threatening voltages can
arise.
Eliminate immediately loose
connections and defective cables.
All connections may only be
contacted when not under voltage.
Safety and protective functions
DANGER
Dangerous movements
Pay attention to sufficient
safeguards in the devices and
facilities. There are dangerous
movements because of faulty
triggering of motors.
Possible correctives are:
Keep clear of the movement area of
the devices or facilities.
Provide sufficient tightness of the
protection cover and housing against
the maximum movement and rotation
energy respectively.
Before opening of the devices or when
entering the danger area stop all
motors completely and secure them
from being switched on again.
Moving parts
DANGER
Self-starting product
If voltage is applied, the motor -- depending
on the type -- can automatically restart
after a mains failure or when blocking has
been eliminated.
Do not stand in the danger zone of
the product.
Switch off the mains voltage when
working on the product and secure it
against switching on again.
Do not make any alterations to the product.
WARNING
Impermissible high loading
After impermissible loading (e.g.
impact, heat, overvoltage, axial or
radial stress) the product can be
damaged and must be stopped
immediately. Check prior to each use
for their proper condition.
WARNING
Rotating parts (shaft / rotor)
Objects like long hair, loose-fitting
garments and jewellery can be caught
and pulled into the rotating motor parts.
Transport
Transport the product only in its original packaging. Secure during
transport.
The vibration values, temperature and climate ranges should not be
exceeded during transport.
Storage
Store the product in a dry and clean environment that is well protected.
Observe the storage temperature referred to in the technical data.
page 2 of 5
Risk of injury!
Do not wear loose-fitting garments or
jewellery or other objects when
working on moving parts.
Protect long hair by wearing a hair
net.
WARNING
251659264Electromagnetic radiation
At the system integration of the product in the
context of electromagnetic compatibility (EMC)
there may occur influences by interaction.
Ensure the electromagnetic compatibility of the
total system.
WARNING
Health risk for persons with heart
pacemakers, metallic implants and
hearing aid devices
These persons are not allowed to
enter the following areas:
areas in which electrical devices and
parts are mounted, run or put into
service.
areas in which motor parts with
permanent magnets are stored,
repaired or mounted.
WARNING
A noise pressure level higher than
70dB(A) is possible depending on the
installation and operating conditions.
Risk of deafness due to noise.
Take technical protective measures.
Provide operating personnel with
protective equipment, e.g. ear
protection.
CAUTION
Hot surface -
Risk of burns
High temperature at motor housing or
heat sink
Provide adequate protection against
accidental contact.
Pay attention to sufficient cooling.
Advertisement
