Summary of Contents for Montana Instruments Cryostation S Series
- Page 1 4117-DOC002 Option User Manual Cart with Electronics Rack Cryostation s-series Version: 1.1 July 2020 www.montanainstruments.com support@montanainstruments.com 101 Evergreen Drive +1.406.551.2796 Bozeman, MT 59715, USA...
- Page 2 This page intentionally left blank.
- Page 3 Montana Instruments. Montana Instruments, Cryostation, nanoReveal, microReveal, Cryo Optic, and ATSM are trademarks of Montana Instruments Corporation. Other brand names used are the property of their respective owners.
-
Page 4: Table Of Contents
Option User Manual Table of Contents Section 1 - Preface ................................ 5 Conventions Used in this Manual ..........................6 1.1.1 Abbreviations ....................................6 1.1.2 Explanation of Safety Warnings ............................. 6 1.1.3 Graphical Symbols ..................................7 General Hazard Information ............................8 Technical Support Information ..........................9 1.3.1 Warranty &... -
Page 5: Section 1 - Preface
All users must read and understand this manual and all other safety instructions before using the equipment. Retain these instructions for future reference. This manual is intended for users of the Montana Instruments products and systems described herein. Users include anyone who may physically interact with the system or peripheral equipment, including installing, setting up, or configuring the system or anyone who may operate system components via operating panels, the supplied user interface, or remote interfaces. -
Page 6: Conventions Used In This Manual
The following abbreviations may be used: ACM: Ancillary Control Module • CAN: Controller Area Network • DMM: Digital Multimeter • HDMI: High Definition Multimedia Interface • Montana Instruments • PCB: Printed Circuit Board • TCM: Temperature Control Module • User Interface •... -
Page 7: Graphical Symbols
Cart with Electronics Rack DANGER Serious personal injury Imminent hazards which, if not avoided, will result in serious injury or death. WARNING Serious personal injury Potential hazards which, if not avoided, could result in serious injury or death. CAUTION Possible personal injury Potential hazards which, if not avoided, could result in minor or moderate injury. -
Page 8: General Hazard Information
Option User Manual 1.2 General Hazard Information The following descriptions are of general hazards and unsafe practices that may result in product damage, severe injury, or death. The products, parts, and components in this manual are to be serviced by authorized Montana •... -
Page 9: Technical Support Information
Montana Instruments service representative. 1.3.1 Warranty & Repairs If the system or parts need to be returned to the Montana Instruments factory or an authorized service center for repair or service, contact an authorized service representative for a return merchandise authorization (RMA) number and instructions on returning the unit. -
Page 10: Section 2 - Option Overview
(rear view shown with VC1110 bottom and SC1160 top) 2.1.1 Intended Use The cart with electronics rack is a rack mount enclosure designed for housing the Montana Instruments system control unit and vacuum control unit. In some configurations, the rack may also contain other rack-mountable control devices supplied by Montana Instruments. - Page 11 Cart with Electronics Rack Installation Requirements The cart should be populated with Montana Instruments-supplied equipment only. The user assumes all risk for populating empty rack spaces with other ancillary equipment. Equipment must be installed in the following order: The vacuum control unit must always be placed in the bottom-most location in the rack.
-
Page 12: Technical Specifications
Option User Manual 2.1.3 Technical Specifications Environmental Specifications Temperature of Environment 5 – 25 °C Humidity 5 – 80% non-condensing Altitude <2000 m Power Specifications Model 4117-530 Mains Power Connector on Unit IEC 60320 C20 Line Voltage 100 – 240 VAC Frequency 50 –... -
Page 13: Section 3 - Option Installation & Handling
Cart with Electronics Rack Section 3 - Option Installation & Handling 3.1 Packaging Contents The cart with electronics rack will arrive in a wooden crate. When ordered with a full system, compatible rack-mounted components, including the Vacuum and System Control Units, may ship pre-loaded in the rack. -
Page 14: Unpacking The Cart With Electronics Rack
Option User Manual 3.2.1 Unpacking the Cart with Electronics Rack The cart with electronics rack ships in a custom crate, typically with all control devices pre-mounted. Locate the rack crate. 1. Unscrew and remove the top lid of the crate. 2. -
Page 15: Connecting System Cables And Power
Cart with Electronics Rack 3.3 Connecting System Cables and Power The standard communication cables and hoses between system components do not change. Refer to the System User Manual for instructions on connecting system cables and other components. The system control unit and vacuum control unit mounted inside the cart will plug into the cart’s power module instead of the wall. - Page 16 Option User Manual 3. Connect the C14 ends to the C13 connectors located on the power distribution module in the cart. Next, connect the cart with electronics rack to power. 4. Locate the C19 main power cord. Ensure the rocker switch on the back base of the cart with electronics rack is off ( o ).
-
Page 17: Section 4 - Appendices
Cart with Electronics Rack Section 4 - Appendices 4.1 Related Documentation For a copy of associated documentation, see below: Document Document Title Location Number 4100-DOC001 System User Manual: www.montanainstruments.com/library/files/4100- Cryostation s-series DOC001.pdf DOC102 General Terms and www.montanainstruments.com/About/Terms Conditions of Sale DOC103 Limited Warranty Agreement www.montanainstruments.com/About/Warranty... - Page 18 Notes...
- Page 19 Notes...
- Page 20 © Montana Instruments® Corporation, All Rights Reserved...
Need help?
Do you have a question about the Cryostation S Series and is the answer not in the manual?
Questions and answers