Advertisement
OF HARMONY CANNOT ACCEPT RESPONSIBILITY FOR ANY DAMAGE
CAUSED BY USE OF THIS FEATURE.
The Chaining Delay Trimmer only affects the chained signal connected to the
Delay In pin and has no effect on unchained devices.
fi g.4
the supplied cable or one manufactured by Doepfer.
Looking at the rear of the module, the negative supply (red stripe) is on the left,
positive supply is on the right (see fi g.4).
The Header marked "+5V" allows you to select whether the +5V is supplied
by the main +5V power bus or derived internally from the +12V supply. Set the
shunts in the position indicated by the PCB legend.
A big thank you to those who have sent in suggestions and comments, keep
them coming!
Comments, samples, suggestions, complaints to:
Drawings and designs ©2022 fl ight of harmony, LLC.
SoS-E v3.0 manual Mar. 2022 — p.5/6
Power
+5V Source Selection
Stuff
fl ight@fl ightofharmony.com
http://www.fl ightofharmony.com
We are tomorrow's shadows...
The power connector header is a
2x8/16-pin shrouded box header which
accepts the standard Doepfer power
cable. This header style is polarized,
meaning the connector can only be
inserted one way, to prevent connecting
the power backwards and damaging the
unit.
This assumes that you are using either
www.fl ightofharmony.com
Advertisement
