Do you have a question about the W639-ED1 and is the answer not in the manual?
Questions and answers
Subscribe to Our Youtube Channel
Summary of Contents for SATO KEIRYOKI W639-ED1
Page 1
Instruction Manual No. 7910-00 Aero Plane Type Wind Speed & Direction Sensor (Model W639-ED1) 3-4, Kanda-kajicho, Chiyoda-ku, Tokyo 101-0045 Japan URL: http://www.sksato.co.jp/english/ EW-S15007...
Page 2
I. General Model W639-ED1 is an Aero plane type Wind speed & direction sensor. Wind speed is output with pulse voltage that is converted by propeller rotation. As for wind direction, the rotation angle of the counterbalanced tail is detected with a brushless potentiometer and voltage of 0 to 1V is output at 0 to 360 °...
Page 3
Ⅲ. Handling 1. Installing the propeller of the sensor (refer to the attached sheet No. 1) Be sure to fully tighten the screw. If the propeller is improperly installed, it may drop, resulting in danger. Fit the propeller onto the propeller shaft by aligning the flat surface on the groove with the flat surface on the propeller shaft.
Page 4
3. Cable and wire connections -- between the sensor and the indicator Use 5-core shielded cable with 0.5 mm or better Usable cable diameter: 8.6 to 10.5 mm Should be far away from high-tension or large-current circuits. A portable lightning arrester is included in the product. If your region is prone to lightning or if a long cable is used, either add a lightning arrester near to the generator or use an underground cable.
Page 5
Attached sheet No.1 How to install the propeller of Wind speed & direction Sensor 1) Fit the propeller onto the propeller shaft by aligning the flat surface on the groove with the flat surface on the propeller shaft. 2) Push in the propeller until it stops, and then tighten the setscrew for the propeller Tightening torque: 14kg/cm to 18kg/cm with a screwdriver.
Page 6
Attached sheet No.2 N mark S mark hole dia. No. Name Materials Tail Glass + polyester resin Body Polycarbonate Stand Polycarbonate Connector 5P 8.5 to 10.5 mm dia. Propeller Polycarbonate Lid of terminal box Polycarbonate Terminal for earth BS Nickel plating...
Page 7
Attached sheet No.3 Wire Diagram Aero plane Type Wind Speed & Direction Sensor Power Wind speed pulse output Power Wind direction voltage output Connector Earth...
Need help?
Do you have a question about the W639-ED1 and is the answer not in the manual?
Questions and answers