Advertisement
Quick Links
W O R K S P A C E S
www.luxorworkspaces.com
800-323-4656
LLMC10
Modular Charging
Cabinet
Assembly Instructions
Tools Required:
Phillips Head Screwdriver
Parts Key
A x 1
Charging Cabinet
B x 1
Cord Wrap
C x 2
Bolt,
Phillips Head
D x 4
Thumbscrew
1
Position cord wrap on the rear of
the cabinet, over the corresponding
threaded mount holes.
C
A
3
Remove the drawer from the
bottom/lower cabinet by pressing
the release lever on each side
of the drawer track.
5
Position a second cabinet on top,
aligning the threaded mount holes.
2
Insert each bolt into a lock washer,
then a flat washer, then use to
attach the casters to the Dolly.
B
4
Remove the rubber caps from
the top of the cabinet.
6
Using the thumbscrews attach the lower
Cabinet to the upper Cabinet.
D
Advertisement
Related Manuals for Luxor LLMC10
Summary of Contents for Luxor LLMC10
- Page 1 flat washer, then use to threaded mount holes. attach the casters to the Dolly. W O R K S P A C E S www.luxorworkspaces.com 800-323-4656 LLMC10 Modular Charging Cabinet Assembly Instructions Tools Required: Phillips Head Screwdriver Parts Key...
- Page 2 Hold mounting plate in desired Pre drill holes in wall and position on the wall, mark the center insert drywall mounts. of the four mounting holes. W O R K S P A C E S www.luxorworkspaces.com 800-323-4656 LLMCWP Modular Charging Cabinet –...
- Page 3 Flip the Dolly over and position the casters over the corresponding threaded mount holes. W O R K S P A C E S IMPORTANT: Position the locking casters on the end next to the power strip. www.luxorworkspaces.com 800-323-4656 LLMCDP Modular Charging Double Cabinet –...
- Page 4 LLMCSP Tools Required: Phillips Head Modular Charging Cabinet – Single Dolly Screwdriver W O R K S P A C E S Assembly Instructions www.luxorworkspaces.com 800-323-4656 Parts Key A x 2 B x 2 C x 1 6 E x 1 6 F x 4 D x 1 6 Caster, Non-Locking...
-
Page 5: W O R K S P A C E S
Parts Key LLMCPH B x 4 Modular Charging A x 1 Cabinet – Dolly Handle W O R K S P A C E S Assembly Instructions www.luxorworkspaces.com Bolt, Socket Head 800-323-4656 C x 4 Split Washer Handle Use the socket head bolts and split washers Line the handle up with the corresponding to attach the handle to the Dolly. - Page 6 Flip the Dollies over, position them end-to-end with the power strips facing out, and position the casters at each corner over the corresponding threaded mount holes. W O R K S P A C E S IMPORTANT: Position at least one set of locking casters on one end. If desired, you can place a locking caster at all four corners.
Need help?
Do you have a question about the LLMC10 and is the answer not in the manual?
Questions and answers